SOLD TEXAS - 1984 FJ60 H55 "Craiggy" Price Update (1 Viewer)

Year

1984

Vehicle Model

1. 60 Series

Location

Houston, Texas United States

Mileage

216570

Color

Beige

“Craiggy” appeared in Houston August 7th, 2016 with 208753 miles. She was a mostly unmolested 1984 Beige FJ60 with Brown interior and has stayed that way. She had a past, most spent in CA and PNW. You can still find past “for sale” post with her history. I was looking for the most rust free 60 I could find, this was her. Under my care she has received the following, along with monthly hub engagement and ethanol free fuel her whole time in the family. She completed two 400 plus mile trips in last 3 months. There is NO rust on the truck, yes rock chips and one or two spots where someone buffed thru paint on an edge. Looks to be mostly original paint (driver door may have some paint work). I have pictures of drip rails and ALL common rust spots. See picture of full box 1984 SMOG equipment that goes with truck for full offer. Dash is NOT covered, just one small tear between two of the speaker perforations. To quote @HemiAlex, "Cleanest 60 out there". Work on the truck done by me, @HemiAlex @FARMAN33 and other Houston OG's. Trans and H55 supplied by @orangefj45 (Georg). Work listed below is partial history of the truck while under my care. Fuel tank recall was done under previous owner, as was updated AC refrigerant. Garage kept since in Houston. Craiggy did have "farm" mirrors at one point, I capped the two small holes on doors. Small dent in roof and a small indentation in hood. Truck sold as is, drive it home and take good care of her. No leaks, no drips - yes the fluids are full.

You can DM me your email address for a link to "shared folder" with 73 pictures and 3 videos
You can drive this one home!

Price is $31,000.00

Carb fan sensor
Install non cracked center dash panel
OME lift from @orangefj45
Hood insulator
Bilstein Shocks (208838)
Sway bar bushings
Headlight washer check valves
OME steering dampener (208940)
New “snake blinder” clips installed
Caster shims (2 degree)
New rubber fuel line from tank to neck and the rubber donut seal in quarter (77213-60030 and 96111-10630)
Knuckles redone and tie rod ends (210641)
Harmonic balancer (OEM)
New timing cover gaskets and seals
Water pump
4 Runner wiper upgrade
Hoses and coolant
Alignment
FJ62 grab handle added (thanks @orangefj45)
Driver side engine mount and rear motor mount/trans mount (210970)
Cap/rotor and plugs
Hand throttle cable with correct pedal setup (@FJ40GURU )
New vac advance on distributor (OEM)
Jim C carburetor and distributor installed (211291)
Jim C air pump replacement pulley
Installed the passenger side motor mount
Plugs - gapped .031 W14EXR-U (211500)
Fuel filter
New axle breathers
Timing and ac idle up adjusted
New exhaust gaskets
Adjusted valves (211651) oil change and filter
Inclinometer installed
Clutch slave and master cylinders installed (211911) OEM clutch hose (90947-02358)
H55 installed with rebuilt transfer case by Georg - Valley Hybrids (212738)
Rebuilt correct drive shafts for H55
Headlight washer bottle - NOT CRACKED
31" BFG AT
LED dome lights
Updated Headlights (Toyota kit)
Vac operated cruise control disconnected
fixed driver seat tear (as usual)
Fluids changed regularly with high zinc (15/40) and GL4 in gears
Large oil filters supplied by @yotafilters (IG)
OEM euro mirrors
Rebuilt PS box - 215600
New Northstar battery (3 months)

There is more I'm sure!

Thanks for looking, Marc

 

[houstonfj40]

Brand New OEM front bumper. I like the look a little better (@wngrog) plus no holes drilled for the damage multiplier that was once a part of her. Thanks Onur for the help years ago getting this bumper.

 

[houstonfj40]

New cleaner look. I like it. New OEM bumper and new OEM end caps.

 

[houstonfj40]

Checked out this 60 yesterday afternoon and it's entirely as-advertised. Body and frame are stupidly clean, shifts/drives very smoothly, and everything is nice and tight. Bump for a great seller, Marc is a total Cruiser enthusiast and entirely transparent. My 80 continues to be the right Cruiser for me, but this is one really awesome 60.

GLWS Marc!

Great 80 BTW

 

[houstonfj40]

Updated $36,000

 

[Beams37]

Just wanted to say nice truck. I would be a buyer if I didn't just buy an 88 pickup and also looking at an 82 (don't tell the wife).

 

[houstonfj40]

Price reduced to $33,000. Dont spend $20k plus and then months to get the truck sorted and $$$. Drive her home.

No trades please, trying to reduce the trucks I own, Thank you!

 

[houstonfj40]

Adding two new front side marker lights, when showing the truck this week, noticed that both front markers had a crack in housing.

 

[houstonfj40]

Still available. PLEASE young men, check with your wife FIRST, before you waste 1.5 hrs of my time, looking and driving the truck - feeling cool. I can't believe the number of young guys who agree on a price, then call back to say the wife said no.

 

[houstonfj40]

 

[houstonfj40]

Price update - $31,000.00