Killer rig - I’ll see you at hollister on truck hill!
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Get me that info on that light please!View attachment 1690584 View attachment 1690585 View attachment 1690586 View attachment 1690587 Found a 41” Amazon single row light that fit nicely in the precut wind damn. Tried a double stack light bar but it just looked to tall
This is a really fun thread to read. BUT. I'm a little disappointed by the lack of gratuitous Slinky flex pictures.
Get me that info on that light please!
There is a lot going on here in a short time. Good work.
How well are your rear slinky coils dealing with being bowed after you installed the rear dc shaft and rotated the pinion up? Or did you relocate the coil buckets on the axle?
I can’t tell for sure from the photos but it appears that you left some angle at the pinion U-joint. I rotated my pinion up for zero angle on the rear joint but that has left my Slee coils rather bowed. This hasn’t changed how the vehicle performs as far as I can tell.
I ask this because I would like to put a set of tapered coils in the my rear since I already have them up front but I have doubts about how well they would like being bowed.
Have you had challenges to overcome with regards to drive line vibrations and spring performance?
I have MT adjustab uppers and lowers and still needed the dc rear shaft. She runs smooth now but my coils are bowed. I think I will relocate the coil buckets when I go to the tapered coils in the rear.So I went with a non DC driveshaft in the rear which i regret. I was informed that it was unnecessary and only adjustable rear uppers with extended lowers would be fine. I have had vibrations since that i suspect need a DC to fix. I've tried angle both directions and still have vibrations. No bowing of the coils yet but i still need to get more time on it.