I recently bought some replacement Rear Spring Gussetts to replace my PO plates. I cut the Spring Hangers off the fabbed plates but now have to reweld Spring Hanger to plate.
With help from Splangy here on mud I have determined that the distance from Pin to Pin Hanger should be 1070 mm. However I mocked up the hanger on my Old Man Emu leaf spring and laid flat to the new gussett and it is measuring up closer to 1090 mms.
Is this a big deal? Or should I just weld the MF and be done with it ???
With help from Splangy here on mud I have determined that the distance from Pin to Pin Hanger should be 1070 mm. However I mocked up the hanger on my Old Man Emu leaf spring and laid flat to the new gussett and it is measuring up closer to 1090 mms.
Is this a big deal? Or should I just weld the MF and be done with it ???