-MaTTi-

Why? Everything is in the engine after that. You don’t want that.

15” won’t fit to FJ Cruiser.

Don't use a K&N filter

Toyota factory air box and filters have been shown to be the best option until you significantly increase airflow with a turbo. K&N filters are rubbish at filtration. There's been legitimate testing done on several brands of filters and K&N...

Put a vacuum gauge on a check, I did that on my 13BT and a silly boost levels the airbox is not a issue.

Please leave it stock. Thank me later.

The stock is good and breaths and filters well. Don’t change, you are only downgrading.

Is it a glow plug and some spacers/extenders? There should be only a plug and the oil pressure sender instead of that ”oil switch” what ever it is… This is how mine looks:

Put an OEM Toyota radiator in it.

2F

Cracked and created pressure to the coolant.

Buy Adonis Raid tune box for it, over 200 hp and 450 Nm. Boost will raise to 1.3 bar. Intecooler is needed then. Or just tune it a little by adjusting fuel control valve. That’s all what you can really do with that electric pump without any...

Yep, it lasted 4 months and almost 5K miles in 1KZ-TE. The first and last chinese head for me.

Got married and The land cruiser was a big part of the wedding. It was the get away vehicle! I have to thank @theglobb And father @Shyrock and their family for capturing some epic photos and video for me that I would other wise not have. I am so...

Any warping? 🤔

From W (yellow wire soldered there afterwards):

Mine cost $30. Well, it’s from 1977.

I am, Redline 75W90NS.

I am in the process of replacing my ct20 turbo on a 2LTE hilux pickup. I decided to go with a holset he211w. Smaller turbo, bolts up nicely, achieves boost at a very low rev range which translates to lower egt’s

Negative, no way I would want to remove that many rivets. I also don't like removing rivets and replacing them with bolts. Ultimately, I think the rivets are much stronger. I galvanized this frame over a decade ago and it doesn't have a spec...

That’s right way to go, this is the multi layer steel gasket which is belonged to latest 3B and 13B-T.

I just bought this kit for VSC switching off: https://a.aliexpress.com/_mtfEpK4 I have not installed it yet, I have to find out do I hide the speedometer light adjusting switch somewhere or where to mount this (every switch place is already in use).