NCFJ
Supporting Vendor
Changing the name of a rig is bad ju ju Very cool rig!!
Official ONSC member buying/selling thread (8 Viewers)
- Thread starter southerncruiser62
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Jim, if you need a place to store the 45 while you get acquainted with the Landy, Nathan says that we have space here for it...wink wink.
I need to roll the clock back to the first of the month and offer the 45 up for sale at $8k.
Bad ju-ju or not, Nigel has to go. As soon as I clean out the interior and powerwash all things that crawl and slither, that name plate goes in the trash.
Had to work to find space for the old thing.
Bad ju-ju or not, Nigel has to go. As soon as I clean out the interior and powerwash all things that crawl and slither, that name plate goes in the trash.
Had to work to find space for the old thing.
elkaholic
Left turn ...freakin wipers!
I like your new project !
Congrats, it was very tempting to me also but I've got so many irons in too many fires, there is no way SWMBO would endorse another project...
I think "Nigel" would be easier to live with than "Crockpot" but in my case the name is pretty much carved in granite so it stays for eternity.
You should be happy that "Dutch Oven" didn't stick.
Great! Thanks for looking. If you want I can take a picture of mine for reference...
Save some money, no need to buy a Land Cruiser, as this is the same thing
http://atlanta.craigslist.org/atl/ctd/4960645330.html
http://atlanta.craigslist.org/atl/ctd/4960645330.html
Measurements for you to refer to. Are you still running 3 speed and original T-case, or did the engine swap also include going to a 4 speed (or auto)? Obviously engine placement also has the ability to require a custom length. Not to worry .... we can figure it out.
Wow. That smells like Crook all the way to NC.
Love this line: "Sometimes We can do a No Credit Check LOAN for those rare people that just had a REPO LAST NIGHT!"
It's a 4 speed. I apparently have a lot to learn about flanges....I was just assuming there were a set of U-joints on either end like on a Jeep CJ....
I'll measure it tonight and see what's what...
Thanks
4 speed is good in that it was considerably stronger than the 3 for small block apps.
In addition to checking out the flange pattern (on both ends) also get a measure of the length since there is no telling what the engine placement did to the stock location.
Never too late! What's 3 weeks among friends?
PM incoming.
Price revised to Best offer.
Pretty sure there is a long line that has formed for @Cirbo 's 45
So does Nigel run? Stop? I had to pull up a few pictures because I wasn't sure what the door handles were actually supposed to look like.
