Measured for a tierod setup made of HD steel tubing. So its about 48" steering arm to arm, but what deduction must I make for the TREs? Anything else I'm forgetting? How to measure for the relay rod?
Measuring for HD tie rods....how?
- Thread starter alex e
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
inkpot
SILVER Star
Howdy! Need to allow for part of the threaded end of the TRE. Don't forget that one end is normal, and the other is reverse thread. John
BudBuilt - Tierods & Draglinks
By the time you buy the steel, buy two taps, one LH and one RH....you can just buy the whole thing and play golf
By the time you buy the steel, buy two taps, one LH and one RH....you can just buy the whole thing and play golf
