93jspec
Cruising Central Texas
Spring is here in the PNW, really my first since moving down here from Alaska. Parting with my FJ40 build has left me kind of listless, but remodeling a home and playing with new toys has taken time away from good ole Spider Pig. I cannot put off the growing to do list any more.
New muffler install with new OEM exhaust bushings from Wits End ( support those vendors )
Steering Stab and from springs from SLEE ( I had an original set of non-progressives front and rear that have been worn out, replaced the rear the 2 summers ago )
Finish installing the dual battery / winch control setup from our friends at 12voltGuy
New to me CB install as well as install an accessory fuse panel from Blue Sea Systems and re position some of the LED alight switches to better location, center console is not ideal, thinking by the rear heater controls. Move CB antenna to mount on front ARB bumper
LED License Plate light on 4x4Labs rear bumper swing out
Oil Change , plugs, wires, Cap and Rotor
Brake adjustment, still softish after ABS uninstall (including making the damn parking brake work)
PFRAN LED interior light installation
Fabricate my roof rack finally...
**Should I install the part time kit I have, or just tolerate the clicking I am getting from my 2 year old (TG) "Longfields" when in 4WD and turning ******stirs the pot******
Seriously considering installing a 9k winch in my rear bumper.
Service both swing outs on rear bumper
*build rear drawer/storage system
Finish it all off with a nice Gray tinted Raptor Liner
Hoping that by posting this my fellow Cruiser Heads will push me along. In Alaska I had my local friends goading me along, have not made those connections here in Oregon yet.
What I have started with:
Glad I have a couple shop vacs handy in the shop.
Thinking of going this route with trimming
New muffler install with new OEM exhaust bushings from Wits End ( support those vendors )
Steering Stab and from springs from SLEE ( I had an original set of non-progressives front and rear that have been worn out, replaced the rear the 2 summers ago )
Finish installing the dual battery / winch control setup from our friends at 12voltGuy
New to me CB install as well as install an accessory fuse panel from Blue Sea Systems and re position some of the LED alight switches to better location, center console is not ideal, thinking by the rear heater controls. Move CB antenna to mount on front ARB bumper
LED License Plate light on 4x4Labs rear bumper swing out
Oil Change , plugs, wires, Cap and Rotor
Brake adjustment, still softish after ABS uninstall (including making the damn parking brake work)
PFRAN LED interior light installation
Fabricate my roof rack finally...
**Should I install the part time kit I have, or just tolerate the clicking I am getting from my 2 year old (TG) "Longfields" when in 4WD and turning ******stirs the pot******
Seriously considering installing a 9k winch in my rear bumper.
Service both swing outs on rear bumper
*build rear drawer/storage system
Finish it all off with a nice Gray tinted Raptor Liner
Hoping that by posting this my fellow Cruiser Heads will push me along. In Alaska I had my local friends goading me along, have not made those connections here in Oregon yet.
What I have started with:
Glad I have a couple shop vacs handy in the shop.
Thinking of going this route with trimming
Last edited: