just google tatton driveline in murray UT.
Group buy for double cardan driveshaft?
- Thread starter bmw635
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
just google tatton driveline in murray UT.
UnderDawg
Wannabe welder
Expect a call from me around 2am... dont mind the heavy breathing and constant meat smacking sounds.
As I stated earlier in this thread to you, all the info you need to know is here. Page 3 post #49.
Horse+water<>drink
Well, mine just came in. Seems to have eliminated all vibration. Very happy to have this done!
FJ809496TLC
80 series addict
Mine came in but won't fit. Bolt pattern is totally different. The one that came from Tatton is 2-3/8" C to C and the bolt holes are too small. I measured the oem shaft which are like 2-5/8" C to C and bolt holes are almost 1/2".
Any updates on the issue?
inkpot
SILVER Star
Contact vendor. Sounds like he sent you Jeep parts. He has been responsive to problems in the past. Good luck. Post up results. John
FJ809496TLC
80 series addict
John, I have been in contact with Curtis and he is very responsive. I think he is just getting forgetful. First time, he sent me 2 rear dc DS with no flanges and I ended up sending them back to him.This time I told him to send just one back to me to see if it will fit.Negative. I think he sent me one for the front instead (smaller bolt pattern) but I just didn't have time to check. He will be sending back the second one and hopefully be the right one. Anybody ordered rear dc ds from him?
Any long term reviews/updates on these tatton driveshafts? Specifically those that milled the flanges.
Dirty Koala
SILVER Star
mine is going strong still
hamishpotter
SILVER Star
Is there availability still?
Dirty Koala
SILVER Star
they are always available, just give Curtis a call. I didn't get mine through the GB, but I think the price waso the same...or very close.
hamishpotter
SILVER Star
Thank you @mryanangel . do the shafts and the joints have grease fittings?
They do have fittings. If you are buying this dc shaft. Have the flanges milled like its supposed to be. I decided not to have mine millled. Bad idea. Just dont want anyone to make the same mistake i did.
