Kinda creepy on the nice house comment. Id watch out for that PabloCruise guy!
Builds FJ55V : This little piggy came home. (2 Viewers)
- Thread starter fre55h
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #442
If he brings some ice cold beers he's welcome over!
- Thread starter
- #444
Easterdrivewaysafari.
HPD Catch can and plumbing all done. 5/8" hose and fittings. 5/8" barb 90* to 3/8' BSP thread adaptor for the intake and blocked off the throttle bottle section
Catch can bolted to 80 series booster.
Throttle body inlet blocked.
HPD Catch can and plumbing all done. 5/8" hose and fittings. 5/8" barb 90* to 3/8' BSP thread adaptor for the intake and blocked off the throttle bottle section
Catch can bolted to 80 series booster.
Throttle body inlet blocked.
Whole lot of plumbing going on.
- Thread starter
- #446
Heater lines, Vac Lines and now these.
They'll bug me enough I'll end up redoing them later.
The old heater line is still bolted ontop of the glow system which I need to remove.
- Thread starter
- #447
Sitting pretty now.
Cutting the rest of the floor rust out next weekend and start making small repairs.
Fabricator coming round as well to take measurements for the barwork and brush guards.
Rear Drivers Section.
Rear Passenger Section.
Cutting the rest of the floor rust out next weekend and start making small repairs.
Fabricator coming round as well to take measurements for the barwork and brush guards.
Rear Drivers Section.
Rear Passenger Section.
gonzopancho
SILVER Star
Last edited:
- Thread starter
- #449
Nice! Everyone will know now!
Do those headlights have the turn signal in them as well?
- Thread starter
- #453
These models don't, but Stedi do offer an All in One.
This is my model. 7" Carbon.
STEDI 7 INCH CARBON Black LED Headlight
STEDI 7 inch Carbon LED Headlight Kit - ADR Approved. Fits a large variety of Jeep CJ, Wrangler, Land Rover Defender, Landcruiser, Nissan GQ Patrol, Harley Davidson Motorcycles, Mercedes Benz G Wagon & Kenworth Truck Models.
www.stedi.com.au
gonzopancho
SILVER Star
Gotta be tacticool 
- Thread starter
- #456
Got round to cuttings the middle section out.
Need to make the Lower Floor Pan section and the upper lip.
1550x200mm with allowances for folds at the ends. Lower floor pan. Then the upper skirt is 50mm with a 150mm rise section. Left the curved section as there was no rust.
Need to make the Lower Floor Pan section and the upper lip.
1550x200mm with allowances for folds at the ends. Lower floor pan. Then the upper skirt is 50mm with a 150mm rise section. Left the curved section as there was no rust.
PabloCruise
SILVER Star
Just noticed in this pic, the heater control is out by the headlight switch! Is that factory? Here in NA, the Warm Pull (ha ha) is in the center section of the dash...
PabloCruise
SILVER Star
Ha ha, once Pablo rolls up in his Pig, there goes the neighborhood!
PabloCruise
SILVER Star
Thanks Mate! That seriously looks like a phat pad.
PabloCruise
SILVER Star
I like the badge treatment on the grille! And I did not know you could front license plate bracket new!
