- Thread starter
- #501
All the parts are in so it is on it's way to get the 4:88's, Detroit in the read and an ARB up front.
Builds FJ 45 Extended Cab Custom Vehicle Build Finally Begins (2 Viewers)
- Thread starter D'Animal
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
don't forget to tie down the hood
Is it running right again?
- Thread starter
- #504
- Thread starter
- #506
- Thread starter
- #507
Installed my Holley350 and throttle cable setup back on it.
I will eventually find all the right parts for the other carburetor but I need to move this around to different locations. Exhaust shop, Gear Shop, etc. It was begcoming a pain using one link to move different vehicles.
I also installed a new fuel pump.
I will eventually find all the right parts for the other carburetor but I need to move this around to different locations. Exhaust shop, Gear Shop, etc. It was begcoming a pain using one link to move different vehicles.
I also installed a new fuel pump.
Last edited:
- Thread starter
- #508
Well I did a few things to it on sunday.
I cut the front U bolts and am pondering the bump stops and mounts.
I cut the front U bolts and am pondering the bump stops and mounts.
- Thread starter
- #509
Began mounting the winch plate. The other one I had on here was not going to work with the shackle reversal.
So are the lockers and gears in?
- Thread starter
- #512
Detroit in the rear, ARB up front. 4:88's. The Viar 480C is mounted and plumbed as well as a 5 gallon air tank.
Last edited:
pbgbottle
Forum Lifer
looking at the bumpstop pic .couldn't ya turn the bumpstop upside down compared to it in the pic and make a plate and attach it to the top of the u-bolts and have it bump up against the frame ? instead of attaching it to the frame and bumpimg into the u-bolt plates. .
- Thread starter
- #514
I'm thinking that is the easiest. One reason I was going to mount on the frame is that the spring plate is a bigger target to hit. If I mounted to the spring plate, the frame is small target to hit at only about 2 1/2" wide.
I'm also looking at the antiwrap bar for the rear.
You got a color picked out yet?
- Thread starter
- #516
Not yet. I kinda Liked the beige. Two people have asked me what I doing to Mudracks rig. It won't be beige.
ToyotaDon
I am here
Dan,
Did you see this one yet?
I know it's not X-cab, but has a similar look....err....to what yours was.
Full link here.
Did you see this one yet?
I know it's not X-cab, but has a similar look....err....to what yours was.
Full link here.
orangefj45
Supporting Vendor
holy crap, the doc is selling his rig? i thought he had well over $200k into it last time i checked and that was well over a year ago............
Trading it in for a Lexus ?
- Thread starter
- #520
Last time I looked on E-Bay it was at $5,600. Some assembly required. He was offereing a rebate for those who paid in cash.
