- Thread starter
- #161
Replaced rear rubber brake line and that fixed the left rear locking issue. Found a sniper on marketplace new in box for almost half price. I wont be rebuilding that carb again!
Builds FARM USE
- Thread starter miller
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #162
Truck is for sale in classified section.
- Thread starter
- #163
So I have been daily driving this rig and it’s growing on me. The one issue I had is the right rear brake was locking up and sometimes not releasing.I replaced all rear wheel cylinders with City Racer units. That issue is gone.
- Thread starter
- #164
My blinker repair failed. Bit the bullet and installed new.
- Thread starter
- #166
Actually tried to use that steering wheel but does not fit! For sale if u want it back lol
- Thread starter
- #167
Tail lights worked fine but lenses cracked on both sides so replaced with new. Shiniest thing on this truck lol.
- Thread starter
- #168
New TRE’s. Also a few pics of wheel wells.
RevISK
SILVER Star
If you’re doing your toe-in here, I believe the goal is to approximate your tire diameter.
- Thread starter
- #170
Makes sense. This did get me close enough. Measured after the test drive and toe is good.
RevISK
SILVER Star
Seems pretty far from an exact science in any case.
Like many things on a 40.
I made a set out of angle aluminum that bolt on to my lugs and are about the length of the tire diameter at the measurement points.
Copied it from the spendy ones I saw online
.
- Thread starter
- #172
Doors are off, top next!
- Thread starter
- #173
A beer running machine. I have been through 3 tanks of gas now and everything is pretty good. Shifting into 3rd gear grinds pretty consistently. If I wait a while it wont do it. I think the synco needs to be replaced. Other than that I really enjoy the rig like it is. Its not a long trip rig, but for around town perfect. Steering is easy with the skinny tires and the drum brakes stop good which I was a bit surprised by. I’ll run it this summer and then see what I want to do to it this winter.
@miller off topic question here, what is the garage door height in this picture? I am guessing 8' door with 10' tall sidewall? I am in the process of drawing up my own shop plans. Thanks!
- Thread starter
- #175
9’ door, 6” curb, 10’ wall.
- Thread starter
- #176
Been waiting for this!
- Thread starter
- #177
Even better
did you ever install the sniper?
- Thread starter
- #179
No. Its running so good now I don't want to mess with it.
- Thread starter
- #180
Saw this today after a cruise. This rig still fighting. I got hinge off one hole needs to be re tapped. One hinge cracked trying to get pin out. Looking for some used ones, but could repair if needed.
