- Thread starter
- #21
OME springs. I followed the instructions and put the taller springs on the right side. Unfortunately I did not realize that since the instructions were intended for vehicles "Down Under" where they drive on the wrong side of the road, I should have done it opposite of what the instructions said. It was leaning pretty bad. I did not measure how much, but it was very noticeable. I had the 1" spacers already and it was much easier to use them to make the left side springs 1/2" taller than the right side than it would be to swap all the springs around. In theory, adding 1" to the springs that were 1/2" shorter should be a net gain of 1/2" lift.
It now sits level, or at least looks level. Again I haven't measured it. That was over 1 1/2 years of daily driving ago with no ill effects, unless that's what caused the blown head gasket. Wait. Now that I think about it. That probably IS what caused it!
Haha I love it. Hopefully my head gasket doesn't decide to go because of mine being off