This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #382
That's the plan. I'm finishing the rear driveline tonight and will drive it around the block a couple of times, but should be good to go!
- Thread starter
- #384
Meet around 8:30 to be on trail around 9:00? Rogers, so folks can park trailers easier.
- Thread starter
- #385
Finished the rear driveline and install. I'm going to run it as-is this trip, get some street miles on it to check vibration, and throw it on a lathe and check for run out if it's terrible.
@boots4 , the Mrs reminded me we have an event Saturday, so will be wheeling Sunday (I know you usually don't do Sunday's), but will have the same schedule.
Last edited:
- Thread starter
- #387
Finished the rear comp cut (didn't want to do that, maybe an extended tub in the near future), and put bolts back where they belong. Tomorrow I have some little things, but otherwise will be packing up the little truck for some fun this weekend.
Looking forward to the trip report. how does the comp cut look? I’m stretched to 105” and absolutely hate the comp cut but the wheel base and driveline length is great to have...
Any pics of the overall stance?
Any pics of the overall stance?
- Thread starter
- #389
I'll grab a pic in the morning.
- Thread starter
- #390
Got a few miles on it around the neighborhood, and it drives so much better now! No driveline vibe (up to 50), corners better, and no clunk under acceleration.
I'm stoked to see how it goes on the trails.
- Thread starter
- #392
2.5"
The base of the rear bumper was at 30.5" before the links, and now sits at 33 even. I'm expecting the rear to settle about an inch over time and when loaded.
Looks great! What coils did you end up using? Do you like the spring rate of them?
- Thread starter
- #394
ZJ progressive coils. Not quite sure on the spring rate, but so far I like them. I'll know better after a day of wheeling though.
- Thread starter
- #395
Today went great. Made the face of airplane hill, and ran the lower loop of crushers. The suspension works great. Only thing needed is the addition of an antirock setup.
Video in a minute.
Video in a minute.
- Thread starter
- #396
Not really a fan of the look of comp cuts but it looks like your 4link suspension works well.
- Thread starter
- #398
I hate the comp cut. I'm going to talk to warrior and see if they can make a set of corners that blend take in account the wheelbase stretch.
- Thread starter
- #399
Let me know if they come up with anything I might be interested!
