655A52-0010 is the part number on the insert. It doesn't bring up anything in searches.
If you would like to borrow mine for design work send me a PM. I can stand to be without it for a little while.
Last edited:
Builds Benjamin’s 3D Prints Build (47 Viewers)
- Thread starter BenCC
- Start date
-
- Tags
- build build thread
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
If you would like to borrow mine for design work send me a PM. I can stand to be without it for a little while.
gregnash
Anal Retentive Analyst
The cupholders I sent him had that part in it. At least I think it did..
I bought this one around the end of 2017 since my original was broken.
Amazon product ASIN B01B8SDZN6
Amazon product ASIN B01B8SDZN6
gregnash
Anal Retentive Analyst
Toyota part 55616-35010.
I have two of these inserts and can take some measurements. Let me know what you need.
Its used, but still shapely.
Height (outside): 60mm
Diameter (outside, bottom): 80mm
Diameter (inside): 77mm
Diameter (outside, top lip): 95mm
Ribs (distance from outside diameter): 5mm
Last edited:
The linked one is an aftermarket knockoff, but it is a replacement for a factory part--my original was broken. (2002, for reference)
Anyone have and advice on running wires up to the overhead acangauage and AUX switch mount that replaces the sunglass holder?
gregnash
Anal Retentive Analyst
Think most run up the drivers a-pillar and then under the headliner.
I just got back from a 2000mi road trip. Had this installed the whole time. The pictures have a little bit of glare due to the screen, I will eventually get some re-takes with the remote turned off. As for the upper knobs, the volume knob on the left is fine because it is smaller, easy to get your fingers on. The channel knob on the right is larger and yes, it could benefit from some clearance above it. However, it's still very usable as is.
I didn't measure to see what the angle of the remote is but he nailed it. It's the best balance of visibility and clearance over the rear view mirror.
I'm going to shoot @BenCC just a handful of observations and see where he wants to go with it. Otherwise it's the cleanest remote setup I've seen on a 100 series. I highly recommend it.
I wrote up installation instructions for my mount, should be the same for Ben’s as far as cable routing:
You can use a standard RJ45 cable, straight-through wiring from plug to plug.
