Builds An Accidental Frame Off.................. (5 Viewers)

[Jdc1]

View attachment 2948866View attachment 2948867

Can’t tame the mountain, Pilgrim.

 

[rkymtnflyfisher]

Decided to weld a floor in my roof rack in preparation for summer fun.

 

[rkymtnflyfisher]

Found a bag o' goodies from @Jdc1 for the headlights I'm installing.

 

[rkymtnflyfisher]

Broke the clamp on my battery cable, had to temporarily hack something together, mounted the relays, tied the harness in, I'm probably going to reconfigure some things under the hood.

 

[Chungas Revenge]

Decided to weld a floor in my roof rack in preparation for summer fun.

View attachment 2955399View attachment 2955400

Well, I think we should call this the Burbank Rack...

 

[rkymtnflyfisher]

New 4frnt MSP 107's for next season, I've demo'd them a few times down at the mountain, by far my favorite.

 

[rkymtnflyfisher]

I was trying to paint the rack after I cleaned it up bit ran out of sunlight and heat!

I guess I'll partake in a cold beer or two.

 

[120mm]

I was trying to paint the rack after I cleaned it up bit ran out of sunlight and heat!

I guess I'll partake in a cold beer or two.

In honor of st Patrick's day, I'm putting away some Irish whisky.

 

[Jdc1]

Found a bag o' goodies from @Jdc1 for the headlights I'm installing.
View attachment 2955401

I just moved that box out of my way the other day.

 

[Chungas Revenge]

In honor of st Patrick's day, I'm putting away some Irish whisky.

Erin Go Bragh...

 

[Chungas Revenge]

New 4frnt MSP 107's for next season, I've demo'd them a few times down at the mountain, by far my favorite.

View attachment 2955415

What do you think? Good enough for big snow country?

 

[middlecalf]

Those skis can only be used with cable bindings and leather lace up boots.

 

[Chungas Revenge]

Some fella named "Jim Bridger" dropped them off on his way west. Figured I could put em' to good use one day.

 

[rkymtnflyfisher]

Decided to pull my deer kicker and winch off to clean them up along with the front bumper.

While that is going on I am also knocking out a knuckle rebuild.

 

[rkymtnflyfisher]

The passenger side was pretty uneventful.

 

[rkymtnflyfisher]

Aside from the wheel bearings on the passenger side looking like they've spun against the outer shim, and a ding on the race from an errant punch, they didn't look too bad.

 

[rkymtnflyfisher]

The driver side was a different story.

I had to pull the studs from the top of the housing, then spin the steering arm off of the top, that's when I found the trunnion bearing was sus.

 

[Jdc1]

The passenger side was pretty uneventful.
View attachment 2958487View attachment 2958488View attachment 2958489View attachment 2958490

Your turn signal lenses are looking pretty beat, keep an eye on the mail.

 

[rkymtnflyfisher]

It steered fine before I pulled everything apart, I'm thinking assembled it was held together fine, when I pulled it apart is when it gave up the ghost.

 

[rkymtnflyfisher]

Your turn signal lenses are looking pretty beat, keep an eye on the mail.

Ahhh yeah!!