Hello again everyone!
I finally bolted on the Aisan carb that I got rebuilt and after a lot of tinkering with it trying to get it to run right, I am not sure what I am missing. I can't get it to idle without misfiring pretty regularly and it has some issues starting sometimes. I have tried following threads about adjusting the idle mixture screw until the RPMs no longer increase, and then backing off of the idle, but I cannot move the idle speed adjustment screw out anymore to adjust the idle. The timing is set to factory specs and I have not found any vacuum leaks and tried the cardboard over the mouth of the carb trick and it just put a good suction on the cardboard and died. Any suggestions?
Thanks in advance!
I finally bolted on the Aisan carb that I got rebuilt and after a lot of tinkering with it trying to get it to run right, I am not sure what I am missing. I can't get it to idle without misfiring pretty regularly and it has some issues starting sometimes. I have tried following threads about adjusting the idle mixture screw until the RPMs no longer increase, and then backing off of the idle, but I cannot move the idle speed adjustment screw out anymore to adjust the idle. The timing is set to factory specs and I have not found any vacuum leaks and tried the cardboard over the mouth of the carb trick and it just put a good suction on the cardboard and died. Any suggestions?
Thanks in advance!