I’ve replaced my mystery OME springs (1.75-2”?) with heavy load linear Robinson springs (3”), this netted me about 1.5” lift.
After doing the alignment, my caster is a -1 degree. However, I DO have the OME caster correction kits installed when OME lift was installed by previous owner. From what...
I was absolutely certain my cold weather no throttle issue was a bad accelerator pedal position sensor (APPS) from everything I found online. Bought a new OEM throttle body with APPS, TPS, and throttle motor last winter and after riding it around in the back floor all year, I finally installed...
I have a 2000 LX470 with about 270k. I replaced the entire throttle body with a NEW OEM unit to fix what I thought was a faulty APPS. I have the same problem and today seems a little worse.
Background: This vehicle is normally garaged and a second vehicle. Last winter I had two occasions where...
I am the proud new owner of a 1994 and it is my daily driver. This is my first official post to the forum.
I was wondering if anyone knows how to install a toddler and/or newborn car seat in a JDM 80 series. One is forward facing and one is rear facing.
I have these hooks on the end of a...
I purchased a 1993 Land Cruiser several years ago. It ran great for a couple of years. I started having issues with a rich code and problems with the distributor. About 6 months ago it wouldn't start so I parked it. I recently decided to work on it again, had a mechanic look at it who replaced...
I've looked all over but can't find the castle nut or washer for a 1969 FJ40 parking brake assembly. I've checked SOR, CCOT, and CruiserTeq. Any help would be appreciated.
Happy New Year! I purchased seat covers from Cruiser Corps which seem great and foam from SOR. I have searched a lot but can't find a good video or picture of where to connect the hog rings for these seats.
Any help is much appreciated!!
I have had my 24gal LRA moved from my old 200 to the new one. I did not personally do the install either time so I don't know what the wiring at the tank actually looks like. Here is the diagram from the install instructions:
My current issue is that the pump does not run and I do not have...
Mounted on the bracket that holds the ignition coil, there is a small black box with two leads, one blue and one black.
The blue wire connects to a black/yellow wire and disappears into the harness above the oil pressure wiring. The black one runs above the fender, is about 18” long, and has a...
Good evening: I'm trying to diagnose a front-end problem with my '78 FJ40 and am looking for some advice from those with more experience and know-how than I possess. i apologize in advance for the length of this post, but I figure the more information I give the better.
Was driving to work the...
I'm having trouble with the 3rd row seat attachment points. The seats don't want to fit properly into the rail and they come loose when I try to raise them up to the side. I think I'm missing a bushing on the rail that is bolted to the wheel well. I'm not sure what it looks like. Can anyone...
Hello All,
Im looking to do an air bag to coil conversion and bypass the AVS and warmimg lights. I figured out a way to make the leveling arms stationary with a locking braket that Toyota sells for the auto leveling headlight sensor sold with the factory TRD lift kit part nubmer (PT595-34220)...
I'm not sure of the actual name of the part. It is the rubber bumpers on the front corners that support the hood when it is closed. Picture with highlighted area below. I was wondering why the hood was tilted when closed. It turns out 1 bumper is gone and the other is pushing through the frame.
I need help from the collective diagnosing a shuddering issue on acceleration and under load I am having with my 92" 80 series. I have combed through the forums and thought I had found the solution a bunch of times...but no joy yet.
She is a 92 so 3F-E engine & A440f 4 speed auto tranny.
On...
I am supposed to be at work right now but my wife needs the 2006 LX right now. She went out to start it and the key would not turn in the ignition and all of the windows and the sunroof all opened at the same time. I am assuming this is security related. It is winter here and I need to get the...
Hello all I am new to mud and new to owning my 80 series. I recently picked up a 1993 cruiser with 172000 miles on it and I love it, I cleaned it up a little put a lift wheels and tires on it and I daily drive it no issues whatsoever its a great rig.... until this morning. I was driving to work...
I have a 1980 FJ40, and ordered some shims and u-bolts from cruiser brothers. 3 of them look just right, but of course the one that rides on the diff is different than the others.
My issue is that the diff u-bolt that was sent is squared off, not rounded like the one that is currently on there...
I am on my first trip in my 96 FZJ80, and the check engine light just popped on. I drove 12 hours from Austin to Santa Rosa Beach. I am staying between Destin and Panama City Beach. I need help/advice on what route to take to get this sorted. I noticed a little bit of fresh looking coolant near...
Neither seat heater works in my 2016. What I'm finding online is not jiving with what I'm seeing with my own eyes. Would someone please be so kind as to tell me which fuse I need to check/replace for the rear seat heaters?
From Googling, it looks like it would be fuse #1 in Fuse Box #1...