Wheel Check?

[Azrocks]

I'm looking at these rims to go with some 35 x 12.5 x 15 KM2's. What do you think? Any other suggestions?
Thanks!

http://www.summitracing.com/parts/PCW-52-5883R2-5/

 

[Poser]

What wheels?

 

[Azrocks]

What wheels?

Oops! Updated....

 

[65-fj45]

I have the same rims on my 45, with 35x12.50x15, 4 wheel parts has them for $55.99
Rock Crawler Series 52 Gloss Black Powder Wheel

 

[Azrocks]

So if I go with the 2.5" backspacing I should be good to go? You don't have any issues with rubbing or anything?

 

[65-fj45]

I went with a deeper back spacing, I think it was 3.25, I'll check when I get home. 2.5 will make the tire stick farther out of the wheel well.

 

[camcruiser13]

i wouldnt go less than 2.5 personally, youll have no issues whatsoever, and the extra width looks and rides nice, (not that its a huge noticable difference.)

 

[Azrocks]

Thanks fellas, I'm going to go ahead and pick up a set of rims and give them a shot.

 

[65-fj45]

The ones I have are 3.50 back spacing and fit fine. with the 2.50 you should have no issues.

 

[jsuthey]

Hi All,I am having fit issues with the Rock Crawler Series 52 blk. 15x8 with a 2.5" backspace.I also thought 2.5 should clear my calipers, but no luck.I only picked up one wheel so far for my spare and tried it on before mounting tire(33x12.50-15).

I am not sure if i like the 2.5" backspace as it does push the wheel out quite a bit.So I am thinking to return the wheel and get a 3.75" or 3.5"??.Then see how that one fits,and if I have to use the spacers or do some grinding I am ok with it.I think I can grind the rear caliper down to clear as the 1/4" spacers will require me to get longer wheel studs.The front already has longer ones from the old swap I did.

I am running the Monte carlo rears and an old Man-a-fre disc.conversion up front.I have 1/4" spacers I was using up front to clear those wilwood calipers(just one on ea.side).The rears clear no prob.with the old wheels.The old wheels are rusted out chrome with black centers w/round holes,15x8 w-a 4" backspace and I only have 4,so I wanted to replace all with the black 52's from 4WP's.

So yea I found this thread searching so well see if anyone else can chime in with the same kind of wheels or offer any advice.

Thanks,John

 

[jsuthey]

Just putting it to the top again to see if any folks are running this same wheel;4wp R.C. Series 52 15x8 with a 2.5" backspace.
Thanks,John