What have you done to your 200 Series this week? (9 Viewers)

[Markuson]

Thanks for the picture, this is extremely helpful for me!
Btw, where do you have the PTT for the Ham stay?

My PTT is near the Start/Ignition.

I bought an extension for the control screen and for the antenna...& that lets me keep it in the right/rear under fit kit of my ARB drawers. Not the storage space, but the normally-unusable spot over the wheel well hump. Then I run a speaker to the other side... Works very well since there really is no need for constant access to the main unit.

Here:

There really isn’t any other use for this small space...so I’m very happy with this spot. If I want to access it for whatever reason, the entire piece comes out...radio attached...with 4 quick hex screws.

-m

 

[Hoosier Daddy]

Just applied WoolWax to the belly of my Cruiser this afternoon.

It may seem kinda early in the season (technically still summer), but the forecast is predicting 3-5 inches of snow on Tuesday! Plus, last year it started snowing in mid-October and did not stop until January. And I'd rather crawl around under the truck when it's 90 degrees as opposed to 30 degrees.

I used the spray cans. It goes on just like Fluid Film in the can does, with no real difference except the lack of stink. The clip-on spray handle comes in extremely handy, because the cans get too slick to keep a grip on them. It took 6 cans to do a great job, whereas an "adequate" job would have taken 3-4 cans.

 

[hblx570]

Just picked up lx570 .... I’m broke now but just had it tinted 3m crystalline and did a deep clean of the interior.... once I have more clarity with the world will work on Maintenance and Get some wheels/tires... overall I love lx570.... although it loves gas!

 

[Ratchey]

Think I need a new bumper... and a few other things...



View attachment 2396957

View attachment 2396958

View attachment 2396959

View attachment 2396960

3 weeks later - New bumper cover, new fender a lot of buffing and some new paint and she is ready to roll again.
I had some big stone chips on the hood that had horrible repairs that were there when I bought it The shop went ahead and repainted the whole hood for me at no charge. Looks better than when I bought it.

 

[Artie]

My PTT is near the Start/Ignition.

I bought an extension for the control screen and for the antenna...& that lets me keep it in the right/rear under fit kit of my ARB drawers. Not the storage space, but the normally-unusable spot over the wheel well hump. Then I run a speaker to the other side... Works very well since there really is no need for constant access to the main unit.

Here:
View attachment 2427065View attachment 2427066View attachment 2427069View attachment 2427067
There really isn’t any other use for this small space...so I’m very happy with this spot. If I want to access it for whatever reason, the entire piece comes out...radio attached...with 4 quick hex screws.View attachment 2427068

-m

Many thanks! Looks like I’m going to either copy this exactly or pretty darn close. Thanks TON!

 

[4literranger485]

I did the AHC sensor lift, installed the Ironman bull bar; still need to fine tune both a little but pleased with the results so far. Took a test drive up some local backroads.

that bumper looks great!

 

[Bullgump]

Did the White Rim Trail...100 miles...to include Lathrop canyon in 10 hours. What a blast. Started in daylight ended at night. Tight turns on narrow cliffs. Extra fuel a must and water. Awesome run and thank goodness i had all the extra lights. I used them all.

 

[Bullgump]

More from the day

 

[Mundiboy]

I have recently retired and now have time to do all those service jobs I used to have done by the dealer.
On my LC 200 4.5l diesel (approx 285,000km) I have just changed the Diff and Transfer case oils. Next task is the transmission oil. Big job for me but thanks to www.project200.com.au video guides it is very manageable.
I have also bought a reversing camera but struggling with accessing power offtakes

 

[Bullgump]

A little night driving up/down mountain always gets the blood pumping.

 

[Simpleman]

Bought a fifth matching wheel/tire (285/70/17 on ICON Six-Speed) and put it into a 5-tire rotation.

Also, spent about 3 hours putting a Loncky leather cover on my steering wheel. Painful, but turned out great. Hated the thin, slippery feeling of the OEM steering wheel.

 

[Atwalz]

Testing bds tundra lift.

 

[RobW0]

I took the dash apart and installed the Naviplus CarPlay unit today.

 

[Sinister]

I took the dash apart and installed the Naviplus CarPlay unit today.

View attachment 2429054

Holy crap, That’ll be a no way for me. Wayyy to much going on there.

 

[RobW0]

Holy crap, That’ll be a no way for me. Wayyy to much going on there.

Looks worst than it is. Wife liked this picture she took better. She just caught it at the right moment as I was pushing my covid hair up.

 

[Sinister]

Looks worst than it is. Wife liked this picture she took better. She just caught it at the right moment as I was pushing my covid hair up.

View attachment 2429077

LOL.....That would be me just reading the instructions even before I started to rip into the dash.

 

[Simpleman]

Looks worst than it is. Wife liked this picture she took better. She just caught it at the right moment as I was pushing my covid hair up.

Agree with Sinister. I'd be going to the forehead a lot on that project.

 

[RobW0]

LOL.....That would be me just reading the instructions even before I started to rip into the dash.

The directions that come with the unit are not that great. With a little preparation from looking at other installs on Mud can make it a lot easier.

 

[Cruiser Jimmy]

Ran Schofield Pass in CO with a 120, 100, 80 and mini-truck.

 

[TeCKis300]

Testing bds tundra lift. View attachment 2428718

Awesome! You work quick and make this stuff look easy. Way to innovate.

Rear axle next?