Red better in the rear than blue. Markedly less stiff, I knew it was better by the time I’d gotten off the driveway and onto the street. I’ve got a curb in my driveway. It’s a Seattle thing. Further 40 min city street drive confirms initial...
Hi,
Selling a pair of like new Peerless auto-trac tire chains. I had them but never used them and now have bigger tires. The tensioner still works fine.
Asking $80.
Fits: 245/70R19.5 255/45R19 255/70R18 255/80R17 255/85R16 265/60R20 265/70R18...
I think there's a creative option likely available, but it's too damn cold right now for me to mock something up in the garage. I might try order a few inexpensive gas strut options from amazon in the spring and see if I can make something work...
Deeper sockets would require some fabrication as there isn’t much space to work with between the Gamiviti panel and the plastic panel it attaches to. That was the potential advantage of the higher profile version @nakman had been considering.
You'd have to experiment, but I think I ruled out deeper sockets. I would like a flush mount rj45/rj11 for my gmrs handset. I'd like to make different use of the panel it is currently mounted in.
While I don't have exactly that setup, I've been running a less aggressive version of AHC long travel for better than 1/2 a year now so might be able to comment.
Downsides - not much if any. Since we're talking about using a larger spacer for...
Stock lower mount full droop
With my bracket full droop
With bracket, shock bottoms out about an inch from bump stop, was hard to get in there to get good picture of the measurement.
I think a 2" bump stop spacer would be necessary, if using...
I really didn't like the amount of fab work required or shipping box size of my first rear bumper, I updated the design to make things for an easier install and shipping.
This design will keep out debris from the rear bumper area and will allow...
Finally installed a winch. Went with the warn vr Evo 12s, and got installed just removing the grill. Whew that was a tight fit but got it all in there.
Wanted to put a few pics on this thread for the LX 570 guys 2009-2015... I have a 2013. Pretty neat creation/product from Tim...
Don't worry I did not take the pics while driving. : )
Once the rest of the RAM mounts arrive, I will post a...
There's a super easy 10 minute hack for more upward clearance.
In the top picture where you show the plastic clip and liner. Take the clip out. Stack the liner over instead of under the metal fender tab. With your fingers, you should be able...
Got mine in yesterday... I like these, I like these a lot. I have the 10mm spacers up front as well.
A few observations for me: less side to side sway (I am pretty top heavy, hehe), a whole lot less nose dive under braking (pros and cons to...
Here’s some discussion on how 24mm is too far unless you do some other supporting mods in the sway bar etc
I assume this is a forum member . . . But not sure whom.
Had to crunch some numbers and do some google fu this morning before answering.
Where I'm landing is I think 20mm is the sweet spot. 24mm may be possible, but I'm trying to keep an eye on balance and durability in regards to protecting the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.