What have you done to your 100 Series this week? (52 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

On Monday next week will be installing the heater hose T's and the little change pocket by the shifter I just ordered from beno, small steps! :)
How much was the pocket? Once the AHC is gone and the switch is pulled, I'd love to add one.
 
How much was the pocket? Once the AHC is gone and the switch is pulled, I'd love to add one.

~$10.. think it was something like 10.52 with the mud discount so that's why I said ~$10 haha
 
In the process of replacing the rack & pinion, the front tie end rods along with front brake job. Haven't gotten the bill from my indy yet but I do know dealer wanted $1000 labor + parts (another $900).
 
Cleaned throttle body and greased ujoints which solved my vibration from 1-2k rpms and better response now.
Most noticeable change after throttle body cleaning.. It was dirty but I guess not enough for a code.

Unrelated note in same day tore down wife's 4runner to the valve covers to do spark plugs, wires, valve cover gaskets, clean power steering screen and degrease everything. Just waiting on my parts now.

So all in all got a bunch done today
 
Took the Maxium out to Lake Quachita today with the family. Had this baby for almost 20yrs now and it has been amazing to us.

ImageUploadedByIH8MUD Forum1406506773.178311.jpg
ImageUploadedByIH8MUD Forum1406506786.811628.jpg



Official Jeep Recovery Vehicle
 
@El Cid I don't think I'd get such a warm welcome that close to Auburn with my license plate;)
 
Yeah, roads into Auburn are two lane, and dimly lit. If I saw your truck I wouldn't vandalize ya, but would take my photo with it:)

I had wanted to take my LC, but it's just cheaper to fly from DFWDFW
 
Changed: Engine Oil, Air Filter, Front Diff Fluid, Transfer Case Fluid, Rear Diff Fluid

Had some body work done.

IMG_20140727_143637-nopm-.jpg


Gotta track down some paint and get it finished up next weekend.
 
Installed my HF Tarheel screwdriver antenna this past weekend. First contact with it was a VK2 station in Australia from my driveway in San Diego! The whip is a quick disconnect and the mast retracts down below the roofline for all those mall runs!
image.jpg
 
Balance/rotated the wheels and lubed the drive shaft. Drives nice and smooth again without the thunk.
 
I relined some kitchen cabinets with cork this weekend, and had some leftvover. So I lined all my center console trays.

No more rattles from change, lights, and whatever else in there : )
 
refurbed both of the sway bars - thanks Beno for the parts!
photo.JPG
 
I've been meaning to do this quite a long while. This morning when I was by Walmart. Decided to buy a box of 10 fuses each amp. Then took out all fuses and replaced with new fuses.

Interesting enough. Those inside the box in the engine bay were clean whereas the fuses coming from the box under the driver side were more corroded.



ImageUploadedByTapatalk1406678727.739709.jpg
 
Last edited:

Users who are viewing this thread

Back
Top Bottom