What have you done to your 100 Series this week? (20 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

White Rim is one we've wanted to do but haven't had enough time to dedicate to it yet since we stop at several other little towns on our way to and fro. Did Long Canyon our first year out there. Gemini Bridges is a great, quick primer trail to get acclimated.

What about Golden Spike Trail? I'm pretty sure the difficult Poison Spider is an off-shoot of that one.
 
Have never been on either one of those.
 
Got the cheap Ebay rear LED taillights. Install went smooth. Fit and finish is alright, we will see how they last. My old ones had a crack in one. I do prefer how they look.

20190614_160147.jpg


20190614_160149.jpg
 
Cut a giant hole in in a pristine fender on my truck!
Before:
20190614_151817.jpg


During:
20190614_162528.jpg


After:
20190614_175747_1.jpg
 
IMG_20190614_155648.jpg


Finally got my AHC dialed. Globes from Pleiades

Front globes had no membrane at all. Rears didn't move with pencil test. 4 graduations to 15 or 16 now. I think the TB needed to be cranked, which I already did, and there was too much pressure on the front globes and they died. Drained and cleaned the reservoir and then bled everything a few times to clear all the gunk out. There was definitely some water in there.
 
Last edited:
@DDMSteve Thanks for taking the time to share with us your experience with the rack.

Esthetics were what initially peaked my interest, so I’m glad to hear it performs as good as it looks.

You got great setup there. I look forward to seeing where your build goes from here.
 
Took a ~1000 mile trip through Southern CO.

Slow going with the camper in tow on the high mountain passes, but all in all the truck did great.

2003902


2003904


2003905
 
Refurbed my e brakes today. New pads and new bell housings.

Also flushed the brake fluid. I was hoping to remedy my spongy brake pedal. I’m not sure there was any change at all. I have a new master cylinder piston assembly I hope to install this summer. That should do the trick.

1998 LC, 341k
A9E46D99-DA33-4117-86CD-616C677F58E2.jpeg


F635EE25-100F-4F3B-8973-BC2A0E552451.jpeg
 
Washed it inside and out. Vacuumed and scrubbed mats, sliders, and bumpers. It's been awhile! And a good reminder that I need to touch up all the places that have been kissed by rocks. And then couldn't resist *starting* husband's truck.

IMG_20190615_155139945_HDR.jpg


IMG_20190615_155128357_HDR.jpg


IMG_20190615_155158393_HDR.jpg


IMG_20190615_155316436_HDR.jpg


IMG_20190615_155233476_HDR.jpg
 
Last edited:

Users who are viewing this thread

Back
Top Bottom