- Thread starter
- #181
more pics
.
.
Builds rocks and rolls
- Thread starter mrqtipp
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #182
the toyota flange bolts up to the machined surface on the axle tube. Then the toyota hub slides on with a seal and two bearings. The tabs accept toyota oem calipers.
.
.
- Thread starter
- #183
The front flange that the 3rd bolts up to is .500 and the rest of the housing is over a quarter inch. The housing is 3.5 OD 3/8 wall
.
.
- Thread starter
- #184
front axle shafts compared to some longfields
.
.
Last edited:
Good Gosh I wish I could weld like that.
Last edited:
- Thread starter
- #186
3rd member protection..
.
.
- Thread starter
- #187
I used some quick disconnect air fittings for venting the tube. Out of the whole tub of fittings none of them were the proper pipe thread pitch. Had to make a couple of mods.
.
.
- Thread starter
- #188
realized that the original spring mounts hang down way to low
.
.
- Thread starter
- #189
plasma cutter and cut of wheels are my friends. I cant seem to stop using them.
more cutting
more cutting
Last edited:
- Thread starter
- #190
The spring perches were 3" and the tube are 3.5.
Put the perches on the end mill and the computer do all the work. The bit is actually spinning during the photo
Put the perches on the end mill and the computer do all the work. The bit is actually spinning during the photo
Last edited:
- Thread starter
- #191
perfect fit after the milling
.
.
Wow. I'm speechless.
That is a hell of a shop you are working in, I wish I had access to all these tools in one place.
Tapage
Club 4X4 Panamá
- Thread starter
- #195
I had the drag racing chasis building next door mill them down. It would have taken me about 45 minutes with grider and they would have came out like s***. The mill cut them perfect in 10 minutes. Technology is crazy
- Thread starter
- #196
called the local break guy (centric) and ordered new rotors and 4 piston calipers. 45 minutes later they arrived, they must of been slow. I love delivery
brake calipers
pulled out some new bolts for the spindles. I need to keep a cleaner work space
brake calipers
pulled out some new bolts for the spindles. I need to keep a cleaner work space
Last edited:
- Thread starter
- #197
packed the wheel bearings
used a wheel seal drift to push the seal on the hub
axle assembled. Put hubs on for now but will be using drive flanges
.
used a wheel seal drift to push the seal on the hub
axle assembled. Put hubs on for now but will be using drive flanges
.
- Thread starter
- #198
put the tires on..
fastned the springs on tube and used some all thread in the front hangers to keep the springs square
fastned the springs on tube and used some all thread in the front hangers to keep the springs square
Last edited:
- Thread starter
- #199
made some plates for the rear hangers.
cut some add on material. used 2" OD 250 wall dom sleeve for the poly bushing
welded them together. I dont like how they look. They are bulky and square.
cut some add on material. used 2" OD 250 wall dom sleeve for the poly bushing
welded them together. I dont like how they look. They are bulky and square.
- Thread starter
- #200
Outboarded and raised the front hangers. mid way on the frame. Used all thread and clamps to keep them on the frame.
used string to check for square
made some gussets for the hangers
used string to check for square
made some gussets for the hangers
