- Thread starter
- #101
Thinking the best bet for running this latch is like this; ignore the bottom piece as it accidentally flipped.
Wondering what sort of "stop" I should put; maybe angle or simple flat stock on the top of the bumper to stop or catch the arm? I do have this rubber L shaped stop I ordered some time back.
Also wondering if I should just go with some 8.8 hardware welded to the spare tire plate, or if I should go with a pressed stud? I'm overthinking things as usual.
I will say, a lot of this would've been easier if I waited much longer.
I ordered myself a CNC plasma table less than a week ago so it should be here sometime next month. Super excited for it!
Wondering what sort of "stop" I should put; maybe angle or simple flat stock on the top of the bumper to stop or catch the arm? I do have this rubber L shaped stop I ordered some time back.
Also wondering if I should just go with some 8.8 hardware welded to the spare tire plate, or if I should go with a pressed stud? I'm overthinking things as usual.
I will say, a lot of this would've been easier if I waited much longer.
I ordered myself a CNC plasma table less than a week ago so it should be here sometime next month. Super excited for it!