- Joined
- Sep 26, 2003
- Threads
- 117
- Messages
- 11,207
- Location
- Lancaster, Ohio, USA
- Website
- www.tlcperformance.com
No, I don't know a clean, pop-in solution.
Was hoping you had one!
Was hoping you had one!
Builds Mission Impossible......My 74 & 76 Build up by a Top Gun Land Cruiser builder :) (1 Viewer)
- Thread starter apeterson
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #1,742
Took the LX450 out of hibernation up north for the day Saturday. The thing is a tank going throught snow. Wish i was not scared of salt.. i would love to drive it more in the winter.
- Thread starter
- #1,743
So i tried this... it works.. but not great. Most people would probably just run it, but i know its not right so, ill keep searching.
I used a single din radio metal sleve, the switches fit in fine and tight. I then made a kydex cover pannel to cover the difference. This pic shows it not cut to proper size yet.
The problem is, there is no good way to mount the metal sleve. The intended tabs dont secure it strong enought so there is movment in the pannels.
- Thread starter
- #1,744
Not sure why but i dont have a pic of it installed with me.
I ordered something similar to this and i am hoping it will work
I ordered something similar to this and i am hoping it will work
- Thread starter
- #1,745
Here is how it looks currently.
- Thread starter
- #1,746
My front speakers are done now also. I installed thin LED lights on them and one under the heater vent. Controlled with a switch on the dash. Happy with how well they work.
- Thread starter
- #1,747
Soooooooooo... the trick is to use 7 switches.. i thought of it but only ordered 6 holders originally, poser also suggested it. I had to order more, put a blank in there for now. Some day i will use it... took about 30 sec worth of sanding with a dremel to fit. Nice to have an empty if i want to add.
Congrats on the new purchase!
Must've been a difficult decision to sell.
Must've been a difficult decision to sell.
Nice Build! Maybe in a few more years for me.....
What kind of lights did you use? And off what website? thanks!!
- Thread starter
- #1,751
I bought them at the parts store in town. Sorry it's been too long now i dont remember the brand.
I used these rocker switch brackets to fit my switches into radio cutout.
Last edited:
- Thread starter
- #1,753
Link not working? I am on my phone however
- Thread starter
- #1,755
Yes. Thats exacty what i am using. On an uncut truck 6 will fit exactly. However the po cut the dash, so 7 must be used.
Man I want a floor mat set like that!
- Thread starter
- #1,757
It is very nice.. i am happy i bought it
Where did you get it?
Thanks!
