Tennessee80

SICK!!

40s are the new 37

Does this count? Picked up some Toyo 37x12.5x17 second hand. Working on step 2, wheels... LOL

Year - 1997 Lift - 4” Slee, Heavies Shocks - Slee/ADS Bumpstops - font - rear - Timbren Body Lift - none Trimming - rear flares small triangle behind wheel Tires- Yokohama MT 37x12.5 G003 Wheels - KMC Machete 17x9 -12mm offset Spacers - none...

Girl was lookin thicc yesterday. 😍

Couple recent pics. Water ended up to the tops of tires at one point.

It was great wheeling with you the other week. Going back to work after 2 weeks off sucks!!

Not on my cruiser, but I've had a set on my Tundra the whole time I've owned it.

bumping this thread.... anyone still running these sequoia rims?

Your vehicle's manual will have the location of all the fuses. The EFI fuse in in the engine bay. On my 1996 LX450, it is on the driver's inner fender. Here are the power circuits for the ECM, PWR and 2nd switch. I agree with TomH...

Cool pics, @Broski !

Congrats on the new 4.88s! :) (from the future)

Heading out to Loon lake in the morning for the Rubithon should be a blast !! I think I'm ready, well be meeting up with the guys from the Rising Sun Club 💪 :cool: can't wait.

My 94 triple locked on 255 85 16 Toyo MT’s. Fresh tint and 2025 Southeast Expo.

Toyo 255/85 R16 Dean Cross Country rims

So, you are confusing me with someone who would/could read a tire sticker?:hillbilly:

Here's my setup. I run it off of my VTOMAN 600 watt at camp, and pass through charge power while driving.

Bump, these are great fridges. they don't hold a ton, but really save space in the back for other gear. they are also very quiet and don't pull much power.

Would you separate?

I wound up buying one of the Smittybilt consoles off Amazon for $150. It's going to take some work to make it fit with the heater but I don't think it will be too bad. I found several threads where other guys have used this one in the FJ62...

By chance going to SAS, I have the ARB you seek.

It fits. 😀 (not mine, but I have a 1fz-fe from a 100-series with a TRD supercharger and a h55f going into a 1972 fj40…)

Time for an introduction here. Name's Anthony, out of Penngrove, Sonoma County. Rig is a '94 80. Factory 3x locked, 37's, slinky, icon, delta suspension. Bellfab bumper, winch. RCVs in the front, 4.88 and regeared part time T case. First time...

Keep in mind if you bring it back to the US you’ll be paying 37.5% tariff on it. Cool build. Swap an FTE in it and keep it ✌🏽