- Thread starter
- #41
The harness doesn't need to be completely hacked apart for this swap. The stock loom is well-protected and routed nicely along the firewall, so I decided just to cut un-needed plugs off the main harness (making sure to properly insulate, and depin and 12v lines to reduce electrical noise).
Harness before
Harness after (can you spot the differences?)
My goal was to make the electronics be plug-and-play, so I sourced the OEM ECU plug for the 1FZ (I have these available for purchase if anyone wants one)
Harness before
Harness after (can you spot the differences?)
My goal was to make the electronics be plug-and-play, so I sourced the OEM ECU plug for the 1FZ (I have these available for purchase if anyone wants one)
Last edited: