I finally finished my frame off restoration which took two years with a little time off here and there. I am looking forward to my next project. That is why I am sad to say I am putting my girl up for sale. I imported this beautiful Fj45 from Australia approximately three years ago. Only drove it around the block once or twice then dove into it. Total tear down, bead blasted the frame then powder coated. All axles torn down new seals and bearings with all new transfer case seals . I had the body acid dipped primed and painted. I added a brand new bed from Awl TEQ (as seen here on Mudd Forum). I assembled the bed and I must say it turned out fantastic, thanks to Awl_TEQ craftsmanship. 
Pretty much stock except for front shackle reverse, Old man-emu 3 1/2 lift, DUI distributor. Every nut, bolt, screw, washer, pin, clip cleaned blasted or replaced. Too much to list! I will post finished picks to see rebuild album leave your Email and I will forward them to you. $45K
Pretty much stock except for front shackle reverse, Old man-emu 3 1/2 lift, DUI distributor. Every nut, bolt, screw, washer, pin, clip cleaned blasted or replaced. Too much to list! I will post finished picks to see rebuild album leave your Email and I will forward them to you. $45K
so green it was.
