How much tear down of the front wheel axels is required to inspect the CV joints for any required greasing or cleaning?
I don’t recall if the wheel bearings have been graded in 20 years. Maybe 10 years ago. There is no leaking, but I’d like to tear them down to check them, and grease them if needed. I don’t expect that the bearings will be bad. I’m just wondering what I need to be prepared to have to replace (seals, gaskets) in getting in there, and if ifs going to require a complete tear down of the knuckle. I hope I don’t have to go that far, but might wondering what the advise would be once I get into it. Should I plan for a full tear down?
Thanks for the advice/recommendations.
I don’t recall if the wheel bearings have been graded in 20 years. Maybe 10 years ago. There is no leaking, but I’d like to tear them down to check them, and grease them if needed. I don’t expect that the bearings will be bad. I’m just wondering what I need to be prepared to have to replace (seals, gaskets) in getting in there, and if ifs going to require a complete tear down of the knuckle. I hope I don’t have to go that far, but might wondering what the advise would be once I get into it. Should I plan for a full tear down?
Thanks for the advice/recommendations.