- Thread starter
- #21
Rad build.
Thanks man. The axles and T case came out of the same BJ60 as the h55 I sold you last winter.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Rad build.
I figured. The only bit I'd look real hard hat would be adding some trussing and certainly add the knuckle gussets. The next week point on cruiser axles is housings that bend.
I at some point need to pick your brain on the LS engine swap. I bought a minty FJ62 with a 5.7l 700r4 that I'd like to swap a 6.0l into.
nice build! looking awesome
Are the bumpstops you are using the GM 15712438?
Do they compress all the way into the cup?
Thanks!
Sorry I don’t have a clue on the part numbers, I can tell you they came from 10 year old coil suspension mini van/envoy/trail blazer at pick a part. They don’t compress up the tube per say. There is a plate welded across the bottom tube as you can see by the distortion marks. These bumps are foam rather than rubber/urethane so the compression rate seams quite linear in comparison. I observed most of the compression happens below the cups. The hope is the are not as harsh as urethane bumps. And for $5 why not eh?
Cool build, I'm following along.
looking good. not that my $0.02 is worth much but is the angle at the rag joint to the box not a bit on the steep side? i guess it wouldnt matter too much as long as she turns freely?
Great build pal, keep at it,