Notcing my FJ60 2F crank pulley has a slight wobble to it (newly rebuilt engine, just installed the crank pulley for the second time after recent rebuilt motor install)
Is this amount of wobble normal? see video
I also noticed the engine is sitting at a slight angle to the left, and am wondering if this is normal? previous owner decided it was a good idea to ram the front cross member onto a rock and bend it -- so the transfer case was always sitting a bit off kilter. it might be mating up better the tranny because its off angle, but just wanted to be sure this isn't causing greater issues ie CRANK pulley wobble...
video::
Thanks,
Dan
Is this amount of wobble normal? see video
I also noticed the engine is sitting at a slight angle to the left, and am wondering if this is normal? previous owner decided it was a good idea to ram the front cross member onto a rock and bend it -- so the transfer case was always sitting a bit off kilter. it might be mating up better the tranny because its off angle, but just wanted to be sure this isn't causing greater issues ie CRANK pulley wobble...
video::
Thanks,
Dan