BlueCruiser84
SILVER Star
- Thread starter
- #161
Front springs I’m doing a RUF pack that’s a mix of fronts/rears and one leaf out of an old Marlin 4” rear pack. I’m not going for a flex monster. Just looking for low height and more articulation than I had with IFS.
For rear springs I have a pack of 57” Allpro rears off a truck I parted out. I’ll mix and match some leaves into it to make it work. If I can keep the front low enough I might be able to get by with my current OME rear springs for a bit.
Steering I’m going to push the IFS box all the way forward and up, rotate the box so it’s “flat”, flat pitman, then notch the frame for the drag link nut. I want the pitman arm swinging juuuusst under the frame rail.
This should give me as low as possible without crazy amounts of fab. Shooting for a frame height of <23” with 35s.
For rear springs I have a pack of 57” Allpro rears off a truck I parted out. I’ll mix and match some leaves into it to make it work. If I can keep the front low enough I might be able to get by with my current OME rear springs for a bit.
Steering I’m going to push the IFS box all the way forward and up, rotate the box so it’s “flat”, flat pitman, then notch the frame for the drag link nut. I want the pitman arm swinging juuuusst under the frame rail.
This should give me as low as possible without crazy amounts of fab. Shooting for a frame height of <23” with 35s.