35"+ Tire Roll-call... (200's only) (16 Viewers)

[TeCKis300]

Here you go. Hopefully I got a pic of what you’re looking for. If not, just let me know. I have full skid plates so mobility was a little tough.

I should’ve put a ruler up to the spacer but didn’t think about it until now. I’ll take one tomorrow when the sun is out.

View attachment 3983762
View attachment 3983763
View attachment 3983764
View attachment 3983765
View attachment 3983766

Thanks! Those are helpful and it does give some clues. Looks like they'll using a healthy wheel spacer and if I had to guess, it's a 1.5" unit. Combined with the +50mm RW offset, would have net offset at 12mm. Combined with some alignment tricks with SPC UCAs. A possible strategy their using to keep off the KDSS bar. The KDSS bar looks to be at stock geometry (no relocation bracket?)

Mind taking some pics of the following:
1. Body mount (just aft of the front tire). Here's mine with the beginnings of a Body Mount Chop (BMC)

2. KDSS/Sway bar relocation. Here's what a KDSS relocation bracket looks like

3. Picture down the side of the car to get a sense of how much offset/poke you have

 

[PhillipPinot]

Thanks! Those are helpful and it does give some clues. Looks like they'll using a healthy wheel spacer and if I had to guess, it's a 1.5" unit. Combined with the +50mm RW offset, would have net offset at 12mm. Combined with some alignment tricks with SPC UCAs. A possible strategy their using to keep off the KDSS bar. The KDSS bar looks to be at stock geometry (no relocation bracket?)

Mind taking some pics of the following:
1. Body mount (just aft of the front tire). Here's mine with the beginnings of a Body Mount Chop (BMC)
View attachment 3983807

2. KDSS/Sway bar relocation. Here's what a KDSS relocation bracket looks like
View attachment 3983808

3. Picture down the side of the car to get a sense of how much offset/poke you have

Will do!