Are you able to make the dome and door lights compatible with Baja Designs dome and rock lights? Not sure the dome lights would fit in the overhead OEM plate, but the rock lights (I think) should work in the door.
100 Series Cupholders, Dome Lights, RAM Mounts & More - Cruiser Design & Manufacturing (9 Viewers)
- Thread starter CruiserDM
- Start date
-
- Tags
- 100 series 3d 3d printing cupholder
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Baja Designs
Supporting Vendor
Hey @samson100,
I have seen a few people make custom 3D printed covers that utilize our dome light for the OEM overhead light. Check out Rovrlab they might have a solution you are looking for!
Best,
Bill
Bill Sonevongxay | Forum Sales & Support
Email: Bill@bajadesigns.com Phone: (760)560-2252
Hmm, this Baja Designs Flush Dome Light Conversion looks promising.
CruiserDM
Supporting Vendor
- Thread starter
- #224
Been slacking on the 100 series a bit while trying to get some products out for the 80 series, I did just redesign my phone tray to fit inside the ashtray rather than out. After trying to find a nice way to run my carplay wire through the dash I finally decided to ditch the cigarette lighter and run a USB bulkhead there, meaning the old tray would be blocking it. This solution should keep me from pulling the dash apart again for the foreseeable future.
I'll be designing a flat or slightly tilted mount for the auxbeam panel to fit in the AHC spot that will work with this tray.
Hoping to finally sit down and make an underhood light mount for the hundo this month. My 80 series project is finally coming to an end and I just have to get the oil pan back on for it to be a running, driving, not-leaking-too-much machine.
I'll be designing a flat or slightly tilted mount for the auxbeam panel to fit in the AHC spot that will work with this tray.
Hoping to finally sit down and make an underhood light mount for the hundo this month. My 80 series project is finally coming to an end and I just have to get the oil pan back on for it to be a running, driving, not-leaking-too-much machine.
Any thoughts on a rhd ram mount below the radio when the where the hazard switch would be. On rhd it's blank.
I think Bencc makes one.
Hello in regard to the cupholder. Do you need to order the xxl one to fit a 3.5" hydroflask? the large mentions the top step being 4" wide but is it deep enough to hold a tall 40oz hydroflask?
Thanks for the reply. I placed my order last night. I went with the xxl just to be safe
It was a breeze to install. My hydroflask fits perfectly along with cell phone. An upgrade I recommend everyone should do.
Need to get these asap.
Did 2nd row cup holders get produced? Mine are broken, so a full replacement insert (perhaps like your taller front ones) would be nice. Thanks in advance!
Order Placed! Looking forward to adding this before my family road trip to Mammoth.
Just ordered the spacers for the fifteen52 wheel caps. Looking forward to getting the setup all together.
