I have 4 15” steel disc brake (welded)wheels. They have 33”x9.5”x15” BFG All Terrain tires on them. The wheels have hubcap clips and are clean. Tires are very old but are good for project rollers. Picture of date code attached. $450. Pick up only.
Have a disc brake setup removed from a 1987 FJ60. Included are the knuckles, hubs, spindles, a pair of calipers good for cores, both birfs, and all the small parts. Not included are the backing plates and the steering arms. Inner axles not included. These parts are in great shape and have been...
I've been lurking on this site for quite some time. I bought a 1966 from a guy who was torturing the poor rig so (unfortunately) I have a lot of work to do. He had put Jeep axles on it which has been a nightmare and I was finally fortunate enough to find some original 1966 FJ40 axles in good...
Disc brake knuckles
wheel hubs
New rotors
New Calipers
New ceramic pads
Warn hub dials
$550.00
Also have low mileage cruiser outfitter Japanese birfields in great condition $150.00
I've been procrastinating rebuilding my knuckles, now it appears my hand is forced as it looks like i've blown an inner axle seal. Hoping to maybe find a toyota mini truck axle to swap disc brakes at the same time. Is 1978-1985 the only years that are compatible? Thanks so much for your...
Have three sets available. All from 60's with the riveted junction block but will work just fine on 40's as well (with a 60 hose) Two are zero rust/damage that would be perfect to blast/paint for a resto. One of the third pair is nice and the other has some damage from the axle being set down on...
I have an 11/1974 FJ40 with an FJ60 disc brake conversion up front and I’m experiencing some intermittent brake drag on the front discs. The booster is a city racer for a 40 with a 40 series disc/drum master. Master is an O’reilly I believe. I didn’t do the conversion so I don’t know it as well...
I will try to list all the meaningful details below:
1968 FJ40 runs and drives, clear 1968 title. (located in zip code 53406)
1976 FJ40 drive train (factory disc brake front end and the 4-speed). Not sure if the rear axle assy is 68 or 76. I could take a look at the rear drive shaft flange to...
Looking for mostly complete or complete FJ55. I am after the 4spd and transfer case along with all associated parts and fine spline axles disc front and drum rear. Would also like a few bits from engine. Figured best bet would be to find a roached out complete or mostly complete parts truck...
I have owned "uglina" for several years (see 27 page build thread on this site). She has front discs and rear drums. Until about 2 months ago, the brakes were great. Recently, the car has started pulling to the left. It has gotten to the point where it pulls pretty hard when you apply the...
Anyone used the SOR disc brake backing shield elimination kit?
Second full brake job in 3 years, one caliper piston seized. Same three years ago. I drive on a lot of dirt roads (VT) and surely this contributes to all the wear. I also did not use OEM calipers and discs but the best NAPA...
Front axle is sold.
I have a front and rear axle from a BJ73 with 4.11 gears in it,these axles are the same with as any 40 series and the only difference is the with of the spring perch mounts.
Cleaning up the shop so they are priced cheap to get them out of my way,shipping can be done with...
BRAND NEW in box FJ40/45 front disc conversion kit. Opened to realize this wasn't going to work for me.
If I send it back JT Outfitters I'll have to pay shipping and a 20% restocking fee.
Before I do that, wanted to offer it up to mud members and make it a win win for everyone
This is the...
5 sets to choose from, all 76-80, bolt-on junction block type. All are west coast rust-free. $200/pr plus the ride. No PMs.
Junction blocks available separately.