I’ve replaced my mystery OME springs (1.75-2”?) with heavy load linear Robinson springs (3”), this netted me about 1.5” lift.
After doing the alignment, my caster is a -1 degree. However, I DO have the OME caster correction kits installed when OME lift was installed by previous owner. From what I understand, those are +2 degree correction. I don’t know how those are clocked exactly, but they “appear” to be correct.
Here’s the question, if I replace those with +2.5” dobinson bushings, that will not be enough right? Just math wise. So the other option is to go with caster plates, which will net me +5 degrees and put me at +2 degrees.
Something seems a bit off here, input would be great.
BONUS QUESTION : Do I need rear panhard bracket?
Most recent alignment:
Previous alignment:
Previous alignment to that before bumper and winch:
After doing the alignment, my caster is a -1 degree. However, I DO have the OME caster correction kits installed when OME lift was installed by previous owner. From what I understand, those are +2 degree correction. I don’t know how those are clocked exactly, but they “appear” to be correct.
Here’s the question, if I replace those with +2.5” dobinson bushings, that will not be enough right? Just math wise. So the other option is to go with caster plates, which will net me +5 degrees and put me at +2 degrees.
Something seems a bit off here, input would be great.
BONUS QUESTION : Do I need rear panhard bracket?
Most recent alignment:
Previous alignment:
Previous alignment to that before bumper and winch:
Last edited: