1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
alia176
Joined:
Aug 21, 2003
Messages:
10,267
Likes Received:
709
Albums:
1
Gender:
Male
Location:
Tijeras, NM
Occupation:
Application analyst IT geek

alia176

Male, from Tijeras, NM

just go outside already. Aug 7, 2017

  • There are no messages on alia176's profile yet.
  • Loading...
  • Loading...
  • About

    Gender:
    Male
    Location:
    Tijeras, NM
    Occupation:
    Application analyst IT geek
    '96 80 series list of mods:
    Slee 4" springs,
    OME sport shocks,
    DIY sliders, double as air tanks,
    DIY rear bumper with tire swingout and fold down tray,
    DIY rear LCA fortification,
    DIY York mounting (first one on a 1FZFE in USA),
    DIY laptop mount for Jotto Desk,
    DIY rear cargo drawers
    DIY front+rear panhard rod adjustors from Slee
    DIY exh manifold food warmer
    DIY mandrel bent up/over 2.5" exhaust

    Warn M10,000# winch + air tank inside front ARB bumper
    ARB front+rear air lockers using factory locker selector switch
    Yaesu FT-8800 HAM radio with custom remote head mount above rearview mirror
    Slee rear UCAs adj
    Slee caster plates
    Slee blue bushings througout except the rear end of front radius arms.
    Slee Tcase skid plate (smaller one, not the huge one)
    Wrangler NW power products dual batt system
    4:56 R&P ratio (did them when I was living at sea level but not good at elevations)
    T-case part time and 3:1 Marks low range gear set
    Aisin front lockout hubs
    OEM front+rear axles and birfs
    Helton water heater, Blue color unit
    On board shower
    OEM aux subtank + TaskLED ECU for transferring fuel
    Infinity Basslink + pioneer speakers + Sony HU
    Cobra CB radio inside 2nd DIN slot
    All LED lights from TaskLED
    Nitto TG 315 75 16s
    Work light on rear spoilder VisionX single pod connected to a manual switch or auto on with reverse lights
    Trailer connector 7 pin RV style blade
    Milford cargo barrier

    Work performed
    Head Gasket
    starter rebuild, few times
    miles of wiring for power outlets
    TIG welded up the crack on exh downpipe at crotch
    Schaffer lubricant in both diffs + Tcase

    2003 4Runner Sport V8

    DIY sliders that hold air
    DIY install of Air Zenith air comp + aux fuse block + dash push button
    2" icon shocks + springs in the rear
    Bilstein 6112s up front set for 1.5" lift
    Front LCA bushings + BJs by Moog
    DIY rear LCA fortfications against bending
    LED warm white under hood and upper rear tailgate
    Swapped out the hood with a non hood scoop, same color
    Gibson SS cat back exhaust
    Falken Wilpeak AT3 265 70 17s with minor rubbing on turns

    Signature

    ~Ali~

    '96 FZJ80 - lifted/locked/aired/wired , '03 4Runner Sport V8 - lifted/aired/wired, not locked yet.

    Tighten your nuts and lube your shafts - often! :D
  • Loading...