- Thread starter
- #21
tlc762 is spot on, they do make 3 to 4 for brake lines with metric fittings already installed- - -easy deal.
Thanks for the input tlc762, I will go see if i can make it happen. I see a youtube video in my future.
Not sure what to do with the throw out bearing. Should I replace it regardless? I think its one of your creations Jim. Can I separate this?
I am going to try to avoid saying one more thing but one more thing, I got the transfer case separated from the tranny by about 8th of an inch or a little more. I can't get it off all the way. I am being somewhat gentle but any recommendations? I dont think the bolt on the end of the out put shaft comes off. I can take a pic to show what i am talking about if needed.