Hello, Almost done with the build and im tuning the motor etc.
350 sbc
previous installed downey conversion
new lUK low profile clutch
new oem master and slave
Installed the new clutch and components.
no drive shafts installed.
with motor running the T-case drive output turns at 5 rpm and can be stopped with my finger
in 1st gear turns at aprox 60 rpm and can be stopped from turning with 2 fingers and very little pressure.
any tips?
can add pics tomorrow.
350 sbc
previous installed downey conversion
new lUK low profile clutch
new oem master and slave
Installed the new clutch and components.
no drive shafts installed.
with motor running the T-case drive output turns at 5 rpm and can be stopped with my finger
in 1st gear turns at aprox 60 rpm and can be stopped from turning with 2 fingers and very little pressure.
any tips?
can add pics tomorrow.