The dual filler is in and it’s a bear to get in there. It took 10mins to get the single filler out and 90 minutes to get the dual in.Electrical is done...... the fuel gauge will just sit there for awhile. Now on to hanging the tank and putting in the dual filler.
View attachment 1828692
Made some spacers for the Kenwood TM-281A to fit in the din size.
View attachment 1828691
After all done, this is all that’s left of that metal support.
View attachment 1828690
Thank goodness that’s done.
My son here is doing the 3 pin Delphi connectors.
You will spend a lot of time in this position. The trick is to get the top of the filler inside the wheel well by getting the tubes as close to the axis of the frame cross member. And yes the tire had to come off. I’ll provide the steps later.
Here a shot from where the aux tank will sit looking out the wheel well.
A shot of the main tank connections which was the easy part.