FJ40 | BJ40

Classifieds: Toyota 40-series Land Cruiser

Filter by prefix:

Lafayette, Louisiana 1966 Toyota Land Cruiser FJ40 w/hard top
1966 Toyota Land Cruiser FJ40, desert beige, excellent patina, outstanding frame & body! Still has some issues but overall in great shape for this vintage! $15,000 cash. Frame / VIN number: FJ4035483 Engine: 6 cylinder in line (Note: motor is circa 1968 or 1969 vintage). Transmission: 3 speed with floor shift Transfer case: Stock Milage: Unknown. Listing this for a friend. Not my vehicle but I have been involved with it since its acquisition, and I can vouch for all that is said in this description. We acquired this 1966 FJ40 with a bad engine out of East Texas in 2019. Actually, the engine was not “bad” – it just had low compression in two of the cylinders, but while we were preparing to address that, there was a hard freeze here...
Richardson, TX  1978 FJ40
Asking $25k Bought in 2005, did a frame off restoration over the next year. Original color was red. Not sure on actual mileage, shows approx 30k, but no idea. Runs and drives great, it is a great weekender, has never been off road. Powder coated frame and around 50 other parts underneath 4 Speed HFS Lift 33's BF Goodrich All Terrain T/A including spare Installed Saginaw Power Steering New lights and decals all around Seats re-worked with new foam and covered. Frames in great shape New hoses, clamps, etc.. Gas tank pulled and refurbished Radiator refurbished List goes on.... I have passenger doors and the ambulance doors for rear (all painted to match at same time). I do not have the top.
Hey Folks, My '68 FJ40 Engine is going to be parted out beginning in February. The engine lost compression heroically at 11K elevation in Colorado last summer. Instead of a re-build I am upgrading to a rebuilt early model 2F engine from Man-A-Fre. Parts I'm pretty sure will be up for grabs: Carb (Rebuilt 2 years ago by Mark's Off Road) with extra parts and a Keyster rebuild kit; Fuel Pump, Air Cleaner Assembly; Distributor; - potentially the manifold (no cracks) and so forth. Will use what I can on the new 2F but I don't think it'll be that much. I wanted to get the word out there early. So just let me know if you're interested in these F Engine parts or others I might not have mentioned. I'll start posting pics once I start pulling...
Bored at work....sorry I didn't have time to break them out into individual ads like OAKWEB does. Props to him! I wish there was a tab for FACEBOOK like there is for Craigslist and EBAY. I tried to leave out any of the "high" priced 40's (obviously this is subjective). Several have original paint in various states of repair. I tried to make sure all were running but may have overlooked one or two. I also tried to leave out any obvious South American 40's if I could tell. I have no affiliation with any of these: https://www.facebook.com/marketplace/item/2528597804034651/?ref=saved&referral_code=null https://www.facebook.com/marketplace/item/2428277297389657/?ref=saved&referral_code=null...
1972 FJ40- What do you think Dad?
Hey all, Apologies if this should have gone in the tech forum- I wasn't sure after reading the User Guide. I'm interested in a 1972 Toyota Landcruiser FJ40 posted in my neck of the woods a few days ago. My dad isn't really a car guy, so I'd like to access the collective wisdom of the group. 21.5K miles. Guys says it starts and runs "good." Needs a clutch master cylinder ("current one leaks onto floorboard") and a valve cover gasket (from email with owner). Rust: "One quarter panel has about a half dollar cancer spot coming through, nothing anywhere else" If I make the trek to look at it, what should I be watching out for? Any mechanical issues I should be able to diagnose, even without being able to drive it far because of the...
1977 FJ40 in Washington State on BAT
I hesitate to link this here, as I know MUD isn't really the place for V8 conversions. But this one is about to wrap up on BAT today. Looks like it might go for a reasonable price. I'm the owner. Let me know if you have any questions... https://bringatrailer.com/listing/1977-toyota-land-cruiser-fj40-83/ Bring-A-Trailer link Google photos link I've had it about 2 years. It came from southern California, where I assume it spent most of it's life based on the sun oxidation and lack of rust. It was heavily oxidized when I bought it. I gave it the CLR, Griots, Penetrol treatment and it came to life. Hopefully you can get a feel from the photos, but it's beautiful in person. As far as I can tell, it is original paint. I've...
1972 Toyota FJ40
Sick of getting mud in your eye? Don’t wanna off-road that $50k RESTO? Wanna make every Jeep owner jealous?? This is for you!! - 350 V8 Chevy Small block - 3 speed Auto - No Frame Rust - Some body rust but nothing punching through Hell, she’s 50 yrs old. I am too and I’ve got body rust! - Runs like a champ. PM me for 70mph video - Falken Wildpeak 35’s with 1,000 miles - Hard top and Doors Got a true cold start video - sat for two weeks in temps below freezing. And a 70mph video. $15,500 I'm not a mechanic, I don't build or work on them. I just drive so my apologies if you have a question about what parts are where. I won't know unless you can tell me where to find what you're looking for.... yeah...I'm that guy... Got the cajones...
1978 FJ40
I am selling my 1978 FJ40 as an incomplete project. It does not seem like I will have the time to finish this and I need to move on. The truck is a 1978 West Coast truck with 84,000 original documented miles. It does not have the original motor , the previous owner blew it up. It has a shackle reversal , 3 inch lift ,Rough Country, mini truck power steering with a Texas Offroad rebuilt box. custom made 8 inch steel wheels with NOS OEM hubcaps, all rust was addressed and the truck was repainted as necessary. New upholstery on the seats and jump seats, Holley carb replaced with a Fuji from City Racer, it starts but needs a tune. I have a FJ60 air cleaner , OEM air horn and bracket, new washer wiper bottle, the previous owner cobbled a...
Michigan 1964 fj40 fst NOT MINE
1964 Toyota Landcruiser FJ40 Soft Top. Brought to Michigan from SoCal in 2012. Original California (Los Angeles area) since new, have the original CA license plates and owner history since 70s. Original paint and interior. Have the original soft doors. Has been in storage in MI while I’ve working on it. Runs, drives & stops. Many new parts installed. Large collection of OE parts that will be included. Serious inquiries only please. $22k OBO https://www.facebook.com/marketplace/item/407719597400409/
1973 Fj40 ROLLER in Southern California
Started to disassemble and Stopped. The Fj40 is complete except for the drive train Original Color I believe to be Capri or Horizon Blue This is the one, if you are looking for a Project ,with a little work could be worth $70-90k The body is in remarkable condition needing a new rear sill, patch on quarters and Driver side outer rocker fix. The floors are original like new. For you California guys NO SMOG Who wants to make there own version of the ICON which would set you back $200k OLD PRICE $-13,500 NEW PRICE $7500 -
1969 F145 Engine/Trans/Tcase $2100cdn
Great complete engine/trans/tcase to drop into your driver or restoration. -1969 FJ40 original F145 - 3 speed column shift currently but can easily be converted to floor shift - transfer case - fan - engine mounts and bracket - full air intake - alternator - starter - exhaust Cosmetically as you can see it needs nothing, blue hoses have been swapped since pictures. Everything runs great and was used around the city all summer no issues at all. Will be available for purchase in the next 30-60 days. Can also be installed for an additional price at 4 wheel auto. Located in Edmonton, Alberta, Canada
Boerne, TX - 1975 Toyota Land Cruiser FJ40
Hello yall, I am officially listing my 1975 FJ-40 up for sale. 1975 FJ-40 FJ40198888 Cygnus White 2F 4 Speed Odometer reads : 96K I have owned it since 2001 and it has always been taken care of. Last Summer it got a new radiator , new clutch, flywheel was turned , new plugs, wires, new brakes, new hoses and belts. The carb was rebuilt, valves were adjusted and ALL fluids swapped. It runs and drives perfectly. 65-66 MPH on the Highway. I swapped the Master and Slave Cylinder a few summers ago. I am asking $28,000. Willing to discuss further and entertain reasonable offers. Thanks
With deep regret I have to sell my 75 Fj40 4 spd Its all apart Was driven on the highway before taken apart, every thing works fine, asking $8.800.00 CASH. Frame and axles coated w Eastwood Ceramic coating, all new brakes, calipers, brake lines, knuckles, new 2" lift springs w hardware, This is a roller, This frame is set up for a Chevy 350 motor w Advance Adapter mounts for motor and transfer case I DONOT HAVE THE 350 MOTOR it was trashed. What I have is a Chevy 4.3 V-6 200 HP w roller cam, 262 ft. lbs. low end torque the body mounts will have to be moved back 2-3`s for fitment, it still has hash marks in cylinder walls and clean in side the valves need to be lapped in and the heads are off and the valves are out, heads need to be...
Boise ID 1974 FJ40 White - Dare I say rare?
@oakweb - This slipped by you :rofl: - Your welcome..... I am NOT affiliated with this and it is not mine - but I am in the Boise area visiting family for the week if someone needs eyes on this. $7850 Be the envy of all the snowplow 40's - in fact with a snowplow on the front you'd have the ultimate 40 - and not an inch of diamond plate! https://boise.craigslist.org/hvo/d/boise-dig-post-holes-or-placer-mine/7409308661.html

Thread Filter

Latest posts

Back
Top Bottom