I think mine was slightly less (~2800) BPM
Builds Work In Progress aka: Badass (5 Viewers)
- Thread starter NeverGiveUpYota
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I think mine was slightly less (~2800)BPM, the 2 5/8” stroke should help! Mine is a little less in that area as well
NeverGiveUpYota
Dare me.
- Thread starter
- #3,923
Thank you!
Anytime!
DickM
SILVER Star
Good call. This will make your life a LOT easier.
Funny how doing more work is sometimes doing less work.
NeverGiveUpYota
Dare me.
- Thread starter
- #3,927
Would it make sense to keep this alt and have it rewrapped?
Probably depends on what it costs vs a new one. I think new parts for tacos will be widely available for much longer than the 60.
NeverGiveUpYota
Dare me.
- Thread starter
- #3,929
Ok, kinda doubt I’ll be putting in a new alt anytime soon (or again in its life) but wasn’t sure if because it’s a denso, it would be worth keeping for something else? 60’s are typically 50amps right? Not sure what the taco one is?
NeverGiveUpYota
Dare me.
- Thread starter
- #3,930
Air hammer… smaller than I thought but heavy duty regardless.
mmm, don't be surprised, they usually are.
It’s not the size that counts. It’s how you use it.
NeverGiveUpYota
Dare me.
- Thread starter
- #3,933
Little taco did a good one today. $50 shipping crate that will be a bee equipment storage shed.
1911
chupacabra
NeverGiveUpYota
Dare me.
- Thread starter
- #3,935
This arrived too.
NeverGiveUpYota
Dare me.
- Thread starter
- #3,936
I hope I wasn’t a dumbass ordering this for a way too rusted together c-channel frame. Time will tell.
pistonpete
SILVER Star
Thats a great tool to have ! 
Surprised the kid’s not driving the taco yet.
I think for everything else you’ve done, c channels are worth it. Even if you’ve gotta weld up some more patches. I’m sure you’ve researched the hell out of this but I’ve seen some folks packing grease behind the new c channels to keep water out. In your environment it might be a good idea to install some grease zirks in a few places so you can maintain it? I thought about doing it if I get to do c channels ever.
I think for everything else you’ve done, c channels are worth it. Even if you’ve gotta weld up some more patches. I’m sure you’ve researched the hell out of this but I’ve seen some folks packing grease behind the new c channels to keep water out. In your environment it might be a good idea to install some grease zirks in a few places so you can maintain it? I thought about doing it if I get to do c channels ever.
NeverGiveUpYota
Dare me.
- Thread starter
- #3,939
Zerks in an area that is flat metal mated to flat metal? But yes lll def sandwich a bunch of grease between. He really wants to be driving it… he’s not quite tall enough to finagle the clutch. I don’t dare start teaching that quite yet. Another year or so. He IS only 8.6 years old. He is the worst passenger driver. Makes me wild.
well, you can let him learn to drive not using the clutch. there's alot of men who don't know how to. yup, being the devil's advocate
