Silveredition
Reactions
1,242

Latest activity Postings About Post areas Events

    • Silveredition
      Silveredition replied to the thread The Hopper Stopper.
      Anyone? Would be great to get some tips before going backwards tomorrow!! Thanks!!
    • Silveredition
      Silveredition replied to the thread The Hopper Stopper.
      Had a bit of a muck- around today.. went to the wreckers and got new passenger door glass and brake master cylinder to load proportioning valve hard lines, installed these with the new master cylinder… I am now wondering how to install the rear...
    • Silveredition
      Update for everyone - the third rev prototype boards arrived. These have the following changes: Thicker copper (2oz vs 1oz) 4 layers - with large redundant copper fills on 3x layers for the current carrying traces that go to the motors Fixed the...
    • Silveredition
      Silveredition replied to the thread The Hopper Stopper.
      Thanks mate!
    • Silveredition
      Silveredition replied to the thread The Hopper Stopper.
      I don’t suppose anyone would know the colour of the fuel gauge wire under the dash? When I was pulling out all extra wires I think I disconnected it thinking it was to do with some add-on accessory, and now my fuel gauge isn’t working…
    • Silveredition
      Silveredition replied to the thread The Hopper Stopper.
      And a couple more
      • IMG_7686.jpeg
      • IMG_7687.jpeg
    • Silveredition
      Gday Mud community! Here is my new project…. This came about due to me being sick a couple of weeks back and searching marketplace for rust free doors for my Hj61 (prob needs more than just the doors though!). I found this fj62 3F carby, 5 speed...
      • IMG_7571.jpeg
      • IMG_7684.jpeg
      • IMG_7685.jpeg
      • IMG_7688.jpeg
      • IMG_7689.jpeg
    • Silveredition
      Thanks mate, it appears that my carby is missing a couple of vacuum ports / parts that yours has?… not sure if someone has changed things or if it was like this from factory. Even more confused now! W
      • IMG_7629.jpeg
      • IMG_7625.jpeg
      • IMG_7623.jpeg
    • Silveredition
      I am hoping someone can help out with where the vacuum lines should go on a ln Australian 3F (1989 fj62 manual). I have highlighted where a couple currently go, but am unsure if this is correct? The red one goes between the inlet manifold a...
      • IMG_7616.jpeg
      • IMG_7613.jpeg
    • Silveredition
      Silveredition replied to the thread Should I??.
      First day - stripped out all non original wiring / alarm and immobiliser / cb radio / cruise control / LP gas system (just not the tanks yet) Managed to get it to run for a few seconds…
      • IMG_7578.jpeg
    • Silveredition
      Silveredition replied to the thread Should I??.
      240v inverter. One of the many add-ons that will be going in the bin…
    • Silveredition
      Silveredition replied to the thread Should I??.
      Done!
      • IMG_7533.jpeg
      • IMG_7543.jpeg
      • IMG_7555.jpeg
      • IMG_7570.jpeg
      • IMG_7571.jpeg
    • Silveredition
      Silveredition reacted to SteveH's post in the thread Should I?? with Like Like.
      Fix the 2nd one (too nice to part out), sell it, and use the $$ to fix yours.
    • Silveredition
      Silveredition reacted to RevISK's post in the thread Should I?? with Like Like.
      Do it for the stripes alone.
    • Silveredition
      Silveredition replied to the thread Should I??.
      Thanks everyone! After sleeping on it before making a decision, I have decided to buy it. Worst case scenario I end up paying $4500 for rust free doors and front quarter panels (all my doors are too rusted to fix) and a perfect interior (can sell...
    • Silveredition
      Silveredition reacted to CruiserTrash's post in the thread Should I?? with Like Like.
      @Silveredition Posting "should I buy this Land Cruiser" on Mud is like walking into the pub and asking the old guys at the bar "should I have a drink??"
    • Silveredition
      Silveredition replied to the thread Should I??.
      That is what I am currently thinking…
    • Silveredition
      Silveredition reacted to FJ404345's post in the thread Should I?? with Like Like.
      You are at the right place, we know about your illness, carry-on !
    • Silveredition
      Silveredition replied to the thread Should I??.
      Anyone know what the SSC sticker in about the 4th photo above is? Inside the front of the front door..
    • Silveredition
      Silveredition replied to the thread Should I??.
      And my hj61
      • IMG_3744.jpeg
    • Silveredition
      Silveredition replied to the thread Should I??.
      A few more pics…
      • IMG_7508.jpeg
      • IMG_7507.jpeg
      • IMG_7506.jpeg
      • IMG_7505.jpeg
      • IMG_7504.jpeg
    • Silveredition
      Silveredition posted the thread Should I?? in 60-Series Wagons.
      I think I have a sickness… I already have a 1988 hj61, however there is a fair bit of rust coming through particularly the doors and gutters / under the gutters etc…mechanically it is perfect, and I have spent a heap on the engine / running gear...
      • IMG_7497.jpeg
      • IMG_7499.jpeg
      • IMG_7500.jpeg
      • IMG_7501.jpeg
      • IMG_7502.jpeg
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Back
Top Bottom