Wire that connects to Oil Filter Housing (1 Viewer)

[thenext20feet]

Be kind this is my first post. I'm in the process of replacing the rack. While trying to get the old one out, I pulled the tiny white wire out of the connector that snaps onto the outside of the oil filter housing. I now need a new connector because I destroyed the old one trying to open it up so I could to reattach the wire. (See the gutted version below.) I'm not having any luck tracking down a part #. 11363 is on the outside of the connector, but that doesn't get me anywhere. Any ideas? Also, it would probably help if I knew the purpose of the wire. I assume it's some kind of pressure or temperature sensor...
2004 Toyota Truck Land Cruiser 4.7L MFI DOHC 8cyl

 

[Dirt J]

Check this out

 

[Mike NXP]

It looks like Dirt J led you there but the 11363 was a big help.

I

 

[thenext20feet]

Thanks a ton ya'll. Great first experience on this site. I'll probably be using this forum a good bit as I slowly turn my wife's hand-me-down into a rig we would all be proud of!