Wrap is done, now just waiting a few weeks send it to Ozark for the chrome delete, front and rear bumper, sliders (finally got some ordered), rack lift and tires!
What have you done to your 200 Series this week? (15 Viewers)
- Thread starter MScruiser
- Start date
-
- Tags
- 200 series
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Battery not disconnected.thank you
Last edited:
What kind/percentage of tint are you running? Fantastic looking rig!
Thx will be excited once everything is done. The tint is 10 in the front and I think 15 or 20 in rear to match the front since the rear glass was already darker.
WhAt color is that?
3m 2080 matte military green
Thank you!
Installed color-matched Rhino 4x4 bumper & skids, Comeup Seal Slim 12.5rs winch, Factor 55 Flatlink, and black sport grille.
For the winch, everything fit pretty well except I needed to rotate the horn right above the control box slightly so I can access the controller's plug on top.
I replaced the fog light casings' zinc-plated screws with black stainless screws.
I also applied a small section of black vinyl wrap to the bottom inside portion of the bumper because I think it otherwise looks funny with the white extending that far on the bottom.
For the winch, everything fit pretty well except I needed to rotate the horn right above the control box slightly so I can access the controller's plug on top.
I replaced the fog light casings' zinc-plated screws with black stainless screws.
I also applied a small section of black vinyl wrap to the bottom inside portion of the bumper because I think it otherwise looks funny with the white extending that far on the bottom.
was this DIY or a shop?
Not a DIY for me. Local guy does it on the side. He takes a long time since it a side thing for him but he treats each car like it is his own.
Little something from ARB
I mean I was at the hangar anyway….it’s not to stop the bolt from coming out, just to prevent opportunistic theft.
Something wrong with that picture. The 200 should get the garage and the 4R should be outside…..First mod to the LC; removed the front mud flaps and trimmed the rear.
Getting 5% tint today and wheel spacers later this week.
Removed front and trimmed rear? Got some pics?First mod to the LC; removed the front mud flaps and trimmed the rear.
Getting 5% tint today and wheel spacers later this week.
All I have for now. I'm going to pop them back off and clean up the cut a little more.
You may have figured it out already - but there is enough adjustment that you do not need the big spacers on the crossmember piece for the transmission skin. I found after one minor hit it had started to deflect ever so slightly so I removed them.
Well I saw that there is a lot of adjustment but I left spacers in place. It did not cross my mind. Good point. Thanks for notice
Since I saw all this nice paintjobs here….
Question. Would you paint the rear bumper also completely (or partiel - see picture) in the gray bedliner that I have already used for the bumper and the covers of the sills?
Question. Would you paint the rear bumper also completely (or partiel - see picture) in the gray bedliner that I have already used for the bumper and the covers of the sills?
