What have you done to your 200 Series this week? (34 Viewers)

[arich]

Buy a grease gun and some good Moly grease.
I like Redline

 

[MScruiser]

Thanks Anthony. Ive got Royal Purple in my gun. That should work, right?

 

[arich]

Yep
Don't put too much in. A few pumps every few months

 

[Desert Nomad]

Thanks Anthony. Ive got Royal Purple in my gun. That should work, right?

Grease dem nipples good

 

[Desert Nomad]

Yep
Don't put too much in. A few pumps every few months

I was under the impression you should keep pumping until clean grease comes out, it usually comes out real dirty

 

[Willy beamin]

Bottom side of the rear trailing arm.

On the revers side is the "hard to reach" area. I just smeared some grease on it to give it protection.

 

[Willy beamin]

I have a couple grease gun fittings and they all failed me for "that area".

 

[arich]

I have heard about people overfilling the prop shaft and putting too much pressure in the transmission yolk
Taking the prop shafts out and taking it apart and cleaning it is on my to do items.

 

[arich]

Let me take some pics of my fittings. That's a rough location

 

[maueth]

Manual says 3350

 

[arich]

Willy
Have you tried a 90 grease gun adapter. 3rd or 6th from the bottom.

Otherwise you may need to swap out the zerk to a 90

 

[Willy beamin]

Nice bag of fittings. I'm going to hunt that down. Thank you

 

[codyaustin5]

First step to my lift.... Thx @beno and @MScruiser

 

[ntsaint]

^ Can you take pics and do a small write up during install? Gonna do that soon myself.

 

[Willy beamin]

Word to the wise. If you run external resi's up front - depending on where that fitting is located on top of your shock you may have to notch out a section of those spacers to make it work. I did with my icons. Not a big deal but I might have been the first to cross that. Now you know.

 

[arich]

Here it is. It's made by Lincoln

These are the ones you need I think

 

[arich]

Found it.

 

[arich]

Hope that helps you out Willy.

 

[Willy beamin]

That's fancy!!!!
Yes thank you very much for finding and posting that. Ima buy one

 

[TJsTACOMA]

Finally got my drawers system re-did. Much better than the last one I made