Me likey!
Source?
What have you done to your 100 Series this week? (55 Viewers)
- Thread starter SHUSH
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Source?
we have printers here at work.. me and another guy have been working on them.. got it now where just about anything can be added.
Just had our local shop install a new starter for my LX. When they were working on the car they saw some fluid (coolant) leaking and saw that one of my heather T's were broken. It actually was all looking all good from a quick glance before a trip, but had completely cracked right where it connects so looked good to go. A job that I just kept putting off knowing it needed to be done and even had the parts for. Well luckily nothing catastrophic happened and the LX is back up and starting right away and running top notch. Thank you Higgy's for the help and a BIG reminder to do your Heather T's and double check everything.
3d printed a sleeve for my swing arm latch so that it can accept standard bike grips. The longer length of this makes things so much easier and prevents me from slamming my hands into the locking pin.
Took her for a quick test drive around. So far feels nice, I got 65mm of down travel, need to finish the body work, build gas tank skid plate, sliders, front bumper for the winch and do the timing belt/new radiator.
Put some up for sale!
oooo, I have the same Tundra/Sequoia(?) wheels. Did you pick up the SLEE spacers? Such a nice wheel.Took her for a quick test drive around. So far feels nice, I got 65mm of down travel, need to finish the body work, build gas tank skid plate, sliders, front bumper for the winch and do the timing belt/new radiator.
View attachment 3966038
View attachment 3966039
Thank you for the 19 solid years of service. Went OEM+ and honestly I may have overspent a little bit on the new oil fill cap 
