Builds What did you do to your Land Cruiser/Toyota/Lexus 4X4 this week? (10 Viewers)

[LandCruiserPhil]

I find listings for both HJ47LP and HJ47LV


Forget Europe got a BJ45LV. About as worthless as a BJ60 on my opinion.

Rumor has it the will be replaced 15BFT

 

[murf]

View attachment 1743938 View attachment 1743939 @murf
A snorkel for the guy that is ok with being different.
Very nice smooth lines
RocaSilva out of Spain

I'm thinking LCP products could pick up this line for the US market?

 

[splitshot]

Also felt froggy enough to get my knees out of the dashboard.

Good one stolen from the passenger side. I need to do some research and see if this is the same nylon gear that goes into an 80 series.

T4R has a decent write-up on this.
Power Seat Repair - Stuck or Barely Moving - DIY - Toyota 4Runner Forum - Largest 4Runner Forum

 

[Cactuscrzr]

Also felt froggy enough to get my knees out of the dashboard.View attachment 1744896 View attachment 1744897

Good one stolen from the passenger side. I need to do some research and see if this is the same nylon gear that goes into an 80 series.

T4R has a decent write-up on this.
Power Seat Repair - Stuck or Barely Moving - DIY - Toyota 4Runner Forum - Largest 4Runner Forum

Gamviti sells replacements.

 

[splitshot]

Thanks, that is who I was talking with months ago. Not sure if it was the same.

 

[Stepmurr]

I'm thinking LCP products could pick up this line for the US market?

Aerodynamic Snorkels from Spain

 

[LostAfrican]

Teasing the guys at HTH with a 200 series

View attachment 1743444

Phil do all your wagons have EU plates on the front? I like it.

 

[Living in the Past]

Also felt froggy enough to get my knees out of the dashboard.View attachment 1744896 View attachment 1744897

Good one stolen from the passenger side. I need to do some research and see if this is the same nylon gear that goes into an 80 series.

T4R has a decent write-up on this.
Power Seat Repair - Stuck or Barely Moving - DIY - Toyota 4Runner Forum - Largest 4Runner Forum

I picked up a set of those gears a long time ago. There were.pretty expensive but included more than just the gear.
Mainly the whole seat. Only took me about fourteen years to buy a 4Runner they would fit in.

 

[Cactuscrzr]

Taunted the rain god(s) with a wash and wax on the ole LC. Sweat me arse off.

 

[Dissent]

Aerodynamic Snorkels from Spain

Link no worky, that thread is 11 years old.

 

[LandCruiserPhil]

Phil do all your wagons have EU plates on the front? I like it.

Required

 

[Stepmurr]

Upgraded to LED lights for the FJ40. The light is very impressive and the LEDs were plug & play.

LED Headlights for Land Cruiser FJ40 FJ55 Mini-Truck - Set of 2

 

[Stepmurr]

Tractor duty for the FJ40

 

[GOLDY]

Yesterday, drivers window went down, no go up. Murf to the rescue. Goes into "Carnac" mode, correctly diagnoses the problem over the phone, gets me into service the same day. Pulls a master window switch out of his hat and has his crew take care of the rest. He also made time for them to do an oil change. Picked the truck up today. Can't thank Murf and the Camelback Toyota service crew enough.

 

[murf]

Goes into "Carnac" mode, correctly diagnoses the problem over the phone,

Over the phone diagnosis is tough, enough guesses and one or two is bound to be correct!

Good to see you and the wife again!

 

[TexAZ]

Been hitting the trail prep pretty hard the past couple weeks. Getting ready for moab/Telluride trip kicking off Saturday.
Installed the "bro-truck" light bar.

I swapped out the gears and went with 4.30 ratio from a tundra and 99 cruiser. The factory locker wouldn't clear the sway bar, so I started looking for alternatives. Found a thread in the 80 section where guys were using small air actuators. Which led me to install on board air...

To control the compressor and light bar and roof lights and locker I found a Chinese knock off s-pod on amazon.
It's basically 1/3 the price and 1/4 the functionality.

Replacing the rear brakes and serpentine belt tonight. Should be ready for more adventures.

 

[blatant]

@TexAZ

Light bar is discrete and actually looks really good, not too bro'ish at all, imo. Unlike the ones on the roof front, with big, silly brackets, that stick way out over the windshield.

fwiw, give those headlamps a quick polish for the full effect!

 

[TexAZ]

So many little things left to do before leaving Saturday.

polish headlights, electrical projects, new windshield...

Lone Cactus auto glass is top notch, they are bringing in new glass from Tucson because the ONE that was in phoenix that would fit the 200 had a crack in it.

this is our third window to get replaced by them excellent work all around.

thanks for the recommendation @murf

 

[blatant]

@TexAZ, this in preparation for 200 in the hills?

 

[LandCruiserPhil]

Been hitting the trail prep pretty hard the past couple weeks. Getting ready for moab/Telluride trip kicking off Saturday.
Installed the "bro-truck" light bar. View attachment 1747856I swapped out the gears and went with 4.30 ratio from a tundra and 99 cruiser. The factory locker wouldn't clear the sway bar, so I started looking for alternatives. Found a thread in the 80 section where guys were using small air actuators. Which led me to install on board air...
View attachment 1747857

To control the compressor and light bar and roof lights and locker I found a Chinese knock off s-pod on amazon.
It's basically 1/3 the price and 1/4 the functionality.
View attachment 1747859

Replacing the rear brakes and serpentine belt tonight. Should be ready for more adventures.

Are you in on the HITR side trip?

I may need to go back to Telluride