R
Reactions
461

Latest activity Postings Post Areas About Post areas

    • R
      That is a ton of coin for a job you should try to so with help. Just changed my h15x for a new h152 5 speed for $3300 in parts and freight- pulling and replacing the t case in process. Dive in.
    • R
      The R141 is a 4sp aluminum case transmission introduced in 1990 for pz/hz engines. Canada got these for their mine trucks 1990-1994. I have seen h41 4speeds (cast iron case) with 21 spline input for 3b engines but those would be several inches...
    • R
      rick_d replied to the thread 1pz injection pump removal.
      First, have you done a timing belt? Helps in getting deep enough to pull pulley and get the pump off. The factory manual is very good at alignment description. The pump pulley also has its own mark to confirm. You will need a dial indicator...
    • R
      2007 mounts will be for the wide nose chassis and would have to be cut down for narrow frames.
    • R
      https://shop.cruiserparts.net/index.php?main_page=product_info&cPath=44_3212_5657&products_id=36295 maybe a source
    • R
      rick_d replied to the thread Instagram @Toyota_cruiserparts_.
      Order something cheap and find out. Ask for a new photo w a known item size etc
    • R
      rick_d replied to the thread Any advice for a young man??.
      Daily driving a Bj is going to be a tough job. A right hand drive prado would also be hard for many drivers. Ask yourself Do i need ac? Can i drive a stick in traffic? How would i deal with overheating engine? What would i do if the truck won’t...
    • R
      rick_d replied to the thread Wanted Transmission Information.
      Ok. I tried all my parts-fu and struck out on the front oil pump. The only clearly different is no lift hooks on side of transmission. I did find a 1/1990 3F- 4 speed H14x transmissions, searched the various output shaft, intermediate plates, t...
      • mark's uzj100 h151.jpg
    • R
      62417-90K02-08 Right side, 2006 model
    • R
      rick_d replied to the thread Wheel Spacers.
      https://www.h-r.com/en/wheel-spacers/ H&R are at least German made. https://www.wheeladapter.com/wheel-spacers are very nice, but not at all cheap. I have some 5/16-8mm spacers they made for my 5 lug front end, but used 35 or 40mm H&R for rear.
    • R
      Sean I will have a few other block photos to show in a bit. As seen in your block, a fair amount of build up is seen. The problem that occurs is that stuff can cut loose and reek havoc on the cooling system. Thanks for bringing this back up.
    • R
      rick_d replied to the thread Plumber recommendations.
      Tankless electric take two 40amp dual breakers on average and the run of power is at least #8 if not the larger #6. You must flush them 1-2 times per year with vinegar to descale them depending on water hardness. Mine is in coat closet, is 5"...
    • R
      The clusters are a trick. ian, do you have the third connection to harness (fits small blue on cluster 2017 an later) or not? I have a 2012 harness and while the 2017+ cluster for hzj operates the tach, certain things don’t work with my harness...
    • R
      I break off the nipple and use a punch that fits just in the remaining bung and pry it out. Actually got a prybar from harbor freight and took off the point and cut length down so i can maneuver the bar around. Use permatex freeze plug goo...
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Back
Top Bottom