The fourth photo in post #17 needs harness wrap/tape, and a grommet.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
What all should be flashing with the hazards on? Currently, nothing is. Only the tail lights flash when the turn signal switch is on right turn. I definitely suck at the electrical stuff so struggle is a good word to describe my work hahaPost #7
I'm fairly certain that some of those lamps above are not supposed to flash. Just the ones on the fender pointing forward, and the ones on the rear bumper?
That blue crimp 'ring' connector looks like you struggled. For that wire, it would have been easier if it was a 16 to 18g (red).
Again, the hazard switch and the turn signal switch are in need of half-century maintenance.
What are the proper bulbs?you also need to make sure you have the proper bulbs in those lights - and the correct relays